Vista Chemtech Pvt Ltd

Elgin Road, Kolkata, West Bengal

Grout HS — is a Ultra High Strength, Free Flowing Non-Shrink, and Chloride Free Grout Conforming to BS-1881, Part 116-1983.

Uses :  Grout- HS is used for grouting of Bolt pockets and base plates grouting of foundation Bolt for all types of machinery in cement, textile, paper & steel industries, bridges bearing pads, columns in pre-cast construction.

Advantage : Grout HS is an economical and easy to use material, requiring only addition of water. It is very easy to mix and Placement can be done with high flow characteristics, rapid strength development, adjustable consistency and compressive strength up to 7ON/mm2 (28 days) is achieved it does not segregate and bleed. It is impact and vibration resistant, non-corrosive to steel and iron, non-toxic and safe to handle.

Application : All grouting areas must be free from the loose concrete, oil, grease, and dust where Grout HS will be placed. The grouting areas to be saturated with water and it are to been sured that no stagnant water is present before application. Add Grout HS Powder to clean water as per the recommended dosages. Keep on mixing with a grout or Concrete mixer till a smooth and even consistency is achieved. Mixed grout should be used within 15 minutes of preparation.
After initial hardening of the grout, it should be kept damp either by wet Hessian Cloth or with pounding for a minimum of seven days. Water and Powder ratio varies from 0.12 to 0.13 depending on the consistency requirement of the site 25Kg of the material will yield approximately 12.0 Litre of Fluid Grout and 11 .0 Litre of plastic Grout mix respectively. Placing conditions including temperature may have to be assessed before pouring the grout at site. Small trials batches may be tried to ascertain best working consistency.

Shelf Life : 6 months from the date of manufacture in unopened condition. To be stored in a cool and dry covered space should be protected from direct sunlight.

Handlinkg Precaution : Grout HS is non-Toxic and Ingestion is to be avoided. If contact with eyes occurs, wash well immediately with water and seek medical advice.

Description : High Strength, free Fbwing Non-Shrink, Non-metallic and Chloride Free Grout conforming to BS-1881, Part 116-1983

Uses : Used for grouting of bolt pockets and b.e plates grouting of Al equipments, Columns in pre-cast construction concrete, Grinders, Beams, Repair & Rehabilitation of Structures

Description : It is mainly developed as versatile non-ionic sealant in concrete structure

Uses : Used for injection into cracks in concrete to stop the flow of moving water

Description : Designed especially for pressure injection grout into concrete for carrying structural repairs. Due to its low viscosity it can be injected into extremely fine cracks also

Uses : Used to fill and seal voids cracks in structure such as bridge and other civil- engineering building,   industrial and residual building such as column, beam, foundation, walls, floor and water retaining structures

Description : Three Component solvent free, free lowing, non-shrinking fast curing epoxy resin system used for pour able epoxy grout

Dosage/Coverage :  

• Comp.A - 2
• Comp.8 - I
• Comp.0 - 5
• Depending upon the gap size

Description : Ukra High Strength, free Flowing Non-Shrink, and Chlonde Free Grout conforming to BS- I 881, Part 116-1983

Uses : Special grouting applications where early strength, development is  the main criteria.