Post Buy Requirement

Other Products / Services #455933

Power Distribution Panels

  • Type Fixed floor mounted / Wall mounted\r\n ACB OR MCCB.
  • Rated Voltage 440 / 415 V 50 Hz
  • PROTECTION CLASS IP42 / IP 54 / IP 55 - Optional
  • MOC CRCA 14 / 16 guage as required, modular construction, interchangeability of compartment
  • RATED CURRENT 800 / 600 A.
  • SHORT CIRCUITĀ LEVEL 35 / 50 KA
  • ENCLOSURE TYPE Indoor / Outdoor
  • BUSBAR SUPPORT SMC/DMC
  • BUSBAR Aluminium/Copper Electrolytic grade
  • Standard IS 8623
  • BUS CHAMBER With safety barrier
  • CABLE CHAMBER Ample Space for Cabling
  • ENTRY Top or Bottom.

Power Distribution Panelsare used for distribution of power on down streams. Since it is located at down stream fault level is normally lower about 20 to 35 KA. Normally it is designed to carry current up to 800A. Advantage of usingPower Distribution Panelis to clear fault locally hence it does not affectUpstream Switchgear.

View Complete Details

MOTOR CONTROL CENTERS

  • Type Modular /non-modular, Fixed/Draw out, single front/double front, dust and Vermin proof
  • PROTECTION CLASS IP42 / IP 54 / IP 55 - Optional
  • MOC CRCA 12 / 14 / 16 guage as per required. Interchangeability of compartment
  • RATED VOLTAGE 380 / 415 / 440 V, 50 HZ, 3 phase, 4 wire
  • RATED CURRENT 3200 A main bus bar.
  • SHORT CIRCUITĀ LEVEL 35 KA / 50 KA for 1 sec
  • ENCLOSURE TYPE Indoor / Outdoor
  • BUSBAR SUPPORT SMC/DMC, Epoxy.
  • BUSBAR Aluminium / Copper, Electrolytic grade
  • STANDARD IS 8623
  • BUS CHAMBER With safety barrier
  • CABLE CHAMBER Ample space for cabling with supports
  • ENTRY Top or Bottom

Motor Control Centersare suitable for operation of motors ranging from 0.5HP to 500 HP capacity.Motor control centercontains various types of starting viz. Direct on line (DOL), Star-Delta, autotransformer, Soft starter etc. Local and remote operation facility, compatible to PCC/DCS based operation.Motor Control Centeris properly ventilated in case of higher size ofmotor starter. Component layout is made so as to facilitate ease of operation and maintenance.

View Complete Details

Relay Panel

Relay and metering panels are used to control HT breaker on remote operation. It contains various protective relays required for the system and metering to measure electrical parameters.
View Complete Details

Vacuum Circuit Breaker Panels

We are offering vacuum circuit breaker panels.3.3, 11, 22 and 33 kv vcb panels33 kv sf6 breaker panels11, 22 kv sf6 load break switch panels.

Additional Information:

Payment Terms : L/C, Western Union

Packaging Details : Sea Worthy Packing

Delivery Time : Mutually Discuss

View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us

List of Other Products by Vidyut Controls and Automations Pvt Ltd from Pune, Maharashtra.
Post Buy Requirement
VC

Vidyut Controls and Automations Pvt Ltd

Add Review

Our Products

  1. Switchgear Panels

    2 Products available
  2. Instrumentation & Control Equipment

    2 Products available
  3. Vacuum Circuit Breakers

    1 Products available
  4. Breaker Panels

    1 Products available
  5. Electric Control Panels

    1 Products available

Other Products / Services

Our product range contains a wide range of

Automatic Power Factor Panel

Automatic Power Factor Control Panel is designed to maintain power factor of plant to unity. To maintain power factor of unity means to achieve demand in KVA on lower side. Power factor is maintained to set value using APFC relay in auto mode where as in case of failure of APFC relay push buttons are used. Auto as well as manual mode is provided for power factor control. Various types of capacitors are used depending on load conditions. Typically MPP, APP or mix dielectric types of capacitors are used. In case of non linear loads like VFD, UPS thyrister switching, suitable reactors are used along with capacitors to filter harmonics.
View Complete Details

Air Circuit Breaker Panels

Air Circuit Breaker Panelsare normally used forprotection of power sourceandelectrical equipmentsituated on downstream. It isolates and protects source from short circuit, overload, earth fault, under voltage, etc.
View Complete Details

Power Distribution Panels

  • Type Fixed floor mounted / Wall mounted\r\n ACB OR MCCB.
  • Rated Voltage 440 / 415 V 50 Hz
  • PROTECTION CLASS IP42 / IP 54 / IP 55 - Optional
  • MOC CRCA 14 / 16 guage as required, modular construction, interchangeability of compartment
  • RATED CURRENT 800 / 600 A.
  • SHORT CIRCUITĀ LEVEL 35 / 50 KA
  • ENCLOSURE TYPE Indoor / Outdoor
  • BUSBAR SUPPORT SMC/DMC
  • BUSBAR Aluminium/Copper Electrolytic grade
  • Standard IS 8623
  • BUS CHAMBER With safety barrier
  • CABLE CHAMBER Ample Space for Cabling
  • ENTRY Top or Bottom.

Power Distribution Panelsare used for distribution of power on down streams. Since it is located at down stream fault level is normally lower about 20 to 35 KA. Normally it is designed to carry current up to 800A. Advantage of usingPower Distribution Panelis to clear fault locally hence it does not affectUpstream Switchgear.

View Complete Details

MOTOR CONTROL CENTERS

  • Type Modular /non-modular, Fixed/Draw out, single front/double front, dust and Vermin proof
  • PROTECTION CLASS IP42 / IP 54 / IP 55 - Optional
  • MOC CRCA 12 / 14 / 16 guage as per required. Interchangeability of compartment
  • RATED VOLTAGE 380 / 415 / 440 V, 50 HZ, 3 phase, 4 wire
  • RATED CURRENT 3200 A main bus bar.
  • SHORT CIRCUITĀ LEVEL 35 KA / 50 KA for 1 sec
  • ENCLOSURE TYPE Indoor / Outdoor
  • BUSBAR SUPPORT SMC/DMC, Epoxy.
  • BUSBAR Aluminium / Copper, Electrolytic grade
  • STANDARD IS 8623
  • BUS CHAMBER With safety barrier
  • CABLE CHAMBER Ample space for cabling with supports
  • ENTRY Top or Bottom

Motor Control Centersare suitable for operation of motors ranging from 0.5HP to 500 HP capacity.Motor control centercontains various types of starting viz. Direct on line (DOL), Star-Delta, autotransformer, Soft starter etc. Local and remote operation facility, compatible to PCC/DCS based operation.Motor Control Centeris properly ventilated in case of higher size ofmotor starter. Component layout is made so as to facilitate ease of operation and maintenance.

View Complete Details

Relay Panel

Relay and metering panels are used to control HT breaker on remote operation. It contains various protective relays required for the system and metering to measure electrical parameters.
View Complete Details

Vacuum Circuit Breaker Panels

We are offering vacuum circuit breaker panels.3.3, 11, 22 and 33 kv vcb panels33 kv sf6 breaker panels11, 22 kv sf6 load break switch panels.

Additional Information:

Payment Terms : L/C, Western Union

Packaging Details : Sea Worthy Packing

Delivery Time : Mutually Discuss

View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us