Automatic Power Factor Control Panel is designed to maintain power factor of plant to unity. To maintain power factor of unity means to achieve demand in KVA on lower side. Power factor is maintained to set value using APFC relay in auto mode where as in case of failure of APFC relay push buttons are used. Auto as well as manual mode is provided for power factor control. Various types of capacitors are used depending on load conditions. Typically MPP, APP or mix dielectric types of capacitors are used. In case of non linear loads like VFD, UPS thyrister switching, suitable reactors are used along with capacitors to filter harmonics.

We manufacture  HT Panels  suitable for medium voltage levels of 3.3 KV, 6.6KV, 11KV, 22KV, 33KV. It is suitable for fault level of 25KA 3 sec. HT Panels are used for operation of  potential transformers , capacitors and motors.     

It is used to supply DG set power in absence of main power. It comprises of control of DG set as well as switching of breakers. In absence of main source it start DG set automatically i.e. Auto mains failure (AMF), synchronizes DG set with each other automatically along with auto load sharing and load dependent startstop of DG set. On resumption of mains it operates respective breakers and switches off DG set.

Relay and metering panels are used to control HT breaker on remote operation. It contains various protective relays required for the system and metering to measure electrical parameters.

Auto mains failure (AMF), synchronizes DG set with each other automatically along with auto load sharing and load dependent startstop of DG set. On resumption of mains it operates respective breakers and switches off DG set.

  Air Circuit Breaker Panels  are normally used for  protection of power source  and  electrical equipment  situated on downstream. It isolates and protects source from short circuit, overload, earth fault, under voltage, etc.