Our Products
Paints
2 Products availableWall Putty
2 Products availablePaints, Varnishes & Wall Putty
1 Products availableOres And Minerals
1 Products availableMachines And Equipments
1 Products availableNatural And Synthetic Resin
1 Products availableDistemper
1 Products availableConstruction Services
1 Products availableTouch Acrylic Emulsion is made of unique forms of co-polymers and pigments available. These ingredients along with exclusive additives provide an optimum dispersion level. It gives a rich matt effect and gives a superior covering when applied for interior and exterior walls with stain guard technology. | ||||||||||
Application Data | ||||||||||
Surfaces to be painted suitable for all smooth plastered surfaces and designed brickwork, wooden surfaces, plywood's, asbestos cement sheets hard and soft boards, etc. | ||||||||||
Primers | ||||||||||
Touch cement primer (Solvent or Water thinnable). 1 coat on previously painted surfaces. 2 coats on new or unpainted surfaces. Putty filled areas should be touched up with a coat of Touch cement primer.
|
| |||||||||||||||||||||
Finishing | |||||||||||||||||||||
Add water slowly to the distemper paste, mixing the contents thoroughly. Continue thinning to application consistency. The normal mixing ratio is 2 parts of water to 3 parts of by volume for the 1st coat. For the 2nd coat the mixing ratio should be 1:1 by volume. Dry overnight between coats. Maximum overcoating interval - 48 hours. | |||||||||||||||||||||
Product Data | |||||||||||||||||||||
Viscosity: 4010 poise Shades: As per Touch shade card. Packs: 1 kg pouch pack, 5, 10 & 20 Kgs. Finish: Smooth and Matt. Covering capacity: 10 to 12 sq. metres per kg per coat depending on the surface and shade. Thinner: Water CAUTION :Do not add more than 65% water by volume. |
| ||||||||||||||
Methods of Application | ||||||||||||||
| ||||||||||||||
Finishing | ||||||||||||||
Use spatula /blade/ trowel on the wall with "bottom to top" configuration. Apply second coat preferably after 4 hrs in hot season & after 12 hrs in cold season. Second coat shall be applied "horizontally" to even out application marks of 1st coat if any. Re-mix putty paste again for 1 minute, if it is left un-disturbed for 30 minutes. Allow complete drying for 3 days and then use fine emery paper to remove application mark, if any. | ||||||||||||||
Velvet water proof effectively increases cement density making the construction totally watertight and free from cracks. It is extensively used to make concrete basement impermeable for water tank, reservoirs walls, roofing, sewer, bathroom, tiles stucco etc. velvet waterproof is free from chloride. | ||||||
Application Data | ||||||
|