Our Products
Filters
2 Products availablePulverizers
1 Products availableIndustrial Blowers, Coolers & Fans
1 Products availableSeparating Machines
1 Products availableCleaning Wipes & Liquids
1 Products available
We are An ISO-9001:2015 Certified Company & Dust Collector Bag Filter Manufacturers in Delhi India. Bag filter dust collectors use filtration to separate dust particulates from dusty gases. They are one of the most efficient and cost effective types of dust collectors available and can achieve a collection efficiency of more than 99% for very fine particulates.
Dust-laden gases enter the baghouse and pass through fabric bags that act as filters. The bags can be of woven or felted cotton, synthetic, or glass-fiber material in either a tube or envelope shape.
The high efficiency of these collectors is due to the dust cake formed on the surfaces of the bags. The fabric primarily provides a surface on which dust particulates collect through the following four mechanisms:
A combination of these mechanisms results in formation of the dust cake on the filter, which eventually increases the resistance to gas flow. The filter must be cleaned periodically.
Bag filter dust collector consist of the following components:
We are An ISO-9001:2015 certified company & air pollution control device cyclone separator manufacturers in Delhi India. Centrifugal collectors use cyclonic action to separate dust particles from the gas stream. In a typical cyclone, the dust gas stream enters at an angle and is spun rapidly. The centrifugal force created by the circular flow throws the dust particles toward the wall of the cyclone. After striking the wall, these particles fall into a hopper located underneath.
The most common types of centrifugal, or inertial, collectors in use today are:
Multiclones are more efficient than single cyclones because they are longer and smaller in diameter. The longer length provides longer residence time while the smaller diameter creates greater centrifugal force. These two factors result in better separation of dust particulates. The pressure drop of multiclone collectors is higher than that of single-cyclone separators.
Cyclone systems consist of the following components:
We are An ISO-9001:2015 Certified Company & Air Pollution Control Equipment Venturi Scrubber Manufacturer in Delhi. An ejector or venturi scrubber is an industrial pollution control device, usually installed on the exhaust flue gas stacks of large furnaces, but may also be used on any number of other air exhaust systems. To this end, an ejector venturi scrubber (as well as the spray tower) uses a preformed spray, the difference is that only a single nozzle is used instead of many nozzles.
This nozzle operates at higher pressures and higher injection rates than those in most spray chambers. The high-pressure spray nozzle (up to 689 kPa or 100 psig) is aimed at the throat section of a venturi constriction.
The ejector venturi is unique among available scrubbing systems since it can move the process gas without the aid of a blower or fan. The liquid spray coming from the nozzle creates a partial vacuum in the side duct of the scrubber.
Because of their open design and the fact that they do not require a fan, ejector venturis are capable of handling a wide range of corrosive and/or sticky particles. However, they are not very effective in removing submicrometer particles.
venturi Scrubber systems consist of the following components:
Bhanpuri, raipuR, Chhattisgarh 