TULEX INDUSTRIAL TOOLS PVT.LTD.

Dombivli, Thane, Maharashtra

These are also called as Screw Driver Bit Holders. It has a 3/8" square drive female on one side and a " Hex Drive female on the other end. It is also available in " Square Drive.

It has a spring release shell which retracts to accept the " hex power type bits and Nut Runners. It is available in Black Industrial Rust Resistant Finish. It is ideal for products where positive bit retention is required.

The name Quick Change Adaptor is quite apt for this tool. It acts as an adaptor / mediator between the impact tool and the fastener tightening tool. This adaptor helps in quickly changing the fastener tightening tool to suit different tools.

These are also called as Screw Driver Bit Holders. It has a 3/8" square drive female on one side and a " Hex Drive female on the other end. It is also available in " Square Drive.

It has a spring release shell which retracts to accept the " hex power type bits and Nut Runners. It is available in Black Industrial Rust Resistant Finish. It is ideal for products where positive bit retention is required.

The name Quick Change Adaptor is quite apt for this tool. It acts as an adaptor / mediator between the impact tool and the fastener tightening tool. This adaptor helps in quickly changing the fastener tightening tool to suit different tools.

Square Drive Adaptors are used as a convertor to permit use of sockets and driving tools of different square drive sizes. It is available in 1/4" (6.35mm), 3/8" (9.5mm),
1/2" (12.7mm), 3/4" (19mm), 1" (25.4mm), 1 1/2" (38.1mm) square drives. The torque capacity of these adaptors is limited to the torque capacity of smaller square drive.

Square Drive Adaptors are used as a convertor to permit use of sockets and driving tools of different square drive sizes. It is available in 1/4" (6.35mm), 3/8" (9.5mm),
1/2" (12.7mm), 3/4" (19mm), 1" (25.4mm), 1 1/2" (38.1mm) square drives. The torque capacity of these adaptors is limited to the torque capacity of smaller square drive.

Impact Square Drive Adaptors are used as a convertor to permit use of sockets with impact wrenches of different square drive sizes i.e. higher or lower. These are available in 1/4" (6.3 mm), 3/8" (9.5mm), 1/2" (12.7mm), 3/4" (19mm), 1" (25.4mm), 1.1/2" (38.1mm) and 2.1/2" (63.5) square drives of adjacent reducing / increasing combinations of male and female drives. These are of two designs - Square Drive Adaptor with two cross holes for conventional impact wrenches and Square Drive Adaptor with groove for locking ring and pin arrangements for impact wrenches with cross hole on male square drive. It may be noted that torque capacity of these Adaptors is limited to torque capacity of smaller square drive sizes.