We also manufacture, supply and export Deep Carved Ekandam Veena. These are available in variegated shapes, sizes and designs to meet the different tastes of the clients. Further, we can also customize the products according to the specific choices and preferences of the clients. Deep Carved Ekandam Veena offered by us is four feet in length, its design consists of a large resonator (kudam) carved and hollowed out of a log (usually of jackwood), a tapering hollow neck (dandi) topped with 24 brass or bell-metal frets set in scalloped black wax on wooden tracks, and a tuning box culminating in a downward curve and an ornamental dragon's head (yali). A small table-like wooden bridge (kudurai) about 2 x 2 x 2 inches is topped by a convex brass plate glued in place with resin. Two rosettes, formerly of ivory, now of plastic or horn, are on the top board (palakai) of the resonator. Four main playing strings tuned to the tonic and the fifth in two octaves (for example, B flat-E flat below bass clef - B flat- E flat in bass clef) stretch from fine tuning connectors attached to the end of the resonator. Across the bridge and above the fretboard to four large-headed pegs in the tuning box. Three subsidiary drone strings tuned to the tonic, fifth, and upper tonic (E flat - B flat- E flat in the tuning given above) cross a curving side bridge leaning against the main bridge, and stretch on the player's side of the neck to three pegs matching those of the main playing strings. All seven strings today are of steel, with the lower strings often wound like those of the lower strings of a guitar.