Tej Engineers

Ahmedabad, Gujarat

ESCR testing is performed by slowly bending the test specimens and placing them in a holding clamp. The clamp and specimens are then placed in a test tube and immersed in a specified reagent. The test tube is sealed and placed in a constant-temperature bath. Multiple test specimens are tested at one time. Reference Standard ASTM D 1693

ESCR is a Property that is highly dependent upon the nature and level of the stress applied and on the thermal History of the Specimen. This equipment consists of a heating Bath to hold water or surface Active Liquid used for the test.

MUFFLE FURNACE is commonly used in Plastics industry to test the percentage of Ash / Filler content in plastic material or finished products. THe TEJ'S MUFFLE FURNACE is quite simple in operation and maintenance too, the furnace having log life custom made heater element with thermal efficient insulation that helps to perform at low cost with high energy saving in operation. .its procures all test related glassware accessories and chemicals to conduct the test with apparatus.

Hydrostatic Pressure Testing Machine are used to find out the resistance to internal pressure of RPVC, CPVC, UPVC, MDPE, HDPE, LLDPE, DWC Pipes, Fittings and valves as per IS, BS, ASTM and many other equivalent standards.

V' Notch making machine is used for making the 'V' Notch over the pipe surface for slow crack growth resistance test.

The two roll rubber mill is a machineused to process natural rubber into various compounds. Two horizontally opposed stainless steel rolls rotate in opposite.

HDT/VSP instrument is used for determining the deflection temperature limit for specific application and comparing the heat softening characteristics of thermoplastic material at a constant load in oil media up to
300 C.'Vicat Softening Point' or 'Heat Deflection Temperature' is one of such yield points, very commonly used for engineering plastics. Vicat test consist of penetrating a unit size indenter in a plastic surface with predefined load under constant rate of environmental temperature rise.

 Hydraulic Moulding Press covers to making the sheets for different testing i.e. tensile, density.etc

OIT Tester to check the oxidation induction time of polymers. The referred ASTM standard recommend two procedures to determine Oxidation induction time test. One is Differential Scanning Calorimeter (DSC) method & second is Differential thermal Analysis (DTA) method.