Solar Radiation Sensor is an ISO-second-class pyranometer that monitors solar radiation for the full solar spectrum range. It connects directly to a YDH-1 RTU, and is used for many meteorological applications.

The SVR allows scientists to determine the surface velocity of water. Designed specifically to measure streams and rivers, theSVRgives you precise speed measurement from a stationary position outside the body of water.

The face panel includes a 3-digit speed display and three buttons: menu, select, and power. Using the menu and select buttons you can control display backlighting, cosine correction, serial communication output mode, and high / low speed range settings.

TheSVRincludes cosine error correction, allowing the unit to account for target angles not parrellel to the direction of water travel.

TheSVRincludes an internal sensor to detect vertical angle, and allows users to set horizontal angles to ensure accurate speeds.

Air temperature and relative humidity probes typically consists of two separate sensors packaged in the same housing. Often relative humidity is measured with a capacitive RH sensor, while air temperature is measured by a PRT. The YDH-1 AWS Air Temperature and Relative Humidity Probes are recommended in humid areas or applications in which accurate measurements of RH (especially above the 90% RH level) are important.Solar radiation shield are required for the sensors if they were to be exposed to sunlight.

The stand-alone SI-3 stationary radar unit sets new standards for size and configurability. Information outputs to a serial port for communication with standard numeric display signs, radar message trailers, computers, and conveyer belt controls.

Part Number: SI-3

The SI-3 was designed to meet a wide variety of demands, including radar message trailers, computers, and conveyer belt controls. A self-contained, stand-alone unit, the SI-3s internal firmware is customizable, allowing changes to range, output format as well as many other options. SI-3 has all the good qualities and technical features of SI-2 but is almost half the size. With weight of 0, 52kg (1, 14lbs) and length of 14, 05cm (5, 6in) SI-3 is easy to fit almost anywhere. Replacing the cable to the side instead of the back like it is at SI-2, the radar shortens even more.

K-Band AntennaDirectionalRS232 Serial PortStationary Mounted Radar Systems5-150mph (8-241 km/h) Speed RangeRange: 1, 500ft (457, 2m : default setting) 3, 000 ft ( 914, 4m : maximum range)Highly Customizable to Meet Customers Needs

Solar Radiation Sensor is an ISO-second-class pyranometer that monitors solar radiation for the full solar spectrum range. It connects directly to a YDH-1 RTU, and is used for many meteorological applications.

The SVR allows scientists to determine the surface velocity of water. Designed specifically to measure streams and rivers, theSVRgives you precise speed measurement from a stationary position outside the body of water.

The face panel includes a 3-digit speed display and three buttons: menu, select, and power. Using the menu and select buttons you can control display backlighting, cosine correction, serial communication output mode, and high / low speed range settings.

TheSVRincludes cosine error correction, allowing the unit to account for target angles not parrellel to the direction of water travel.

TheSVRincludes an internal sensor to detect vertical angle, and allows users to set horizontal angles to ensure accurate speeds.

Air temperature and relative humidity probes typically consists of two separate sensors packaged in the same housing. Often relative humidity is measured with a capacitive RH sensor, while air temperature is measured by a PRT. The YDH-1 AWS Air Temperature and Relative Humidity Probes are recommended in humid areas or applications in which accurate measurements of RH (especially above the 90% RH level) are important.Solar radiation shield are required for the sensors if they were to be exposed to sunlight.

The stand-alone SI-3 stationary radar unit sets new standards for size and configurability. Information outputs to a serial port for communication with standard numeric display signs, radar message trailers, computers, and conveyer belt controls.

Part Number: SI-3

The SI-3 was designed to meet a wide variety of demands, including radar message trailers, computers, and conveyer belt controls. A self-contained, stand-alone unit, the SI-3s internal firmware is customizable, allowing changes to range, output format as well as many other options. SI-3 has all the good qualities and technical features of SI-2 but is almost half the size. With weight of 0, 52kg (1, 14lbs) and length of 14, 05cm (5, 6in) SI-3 is easy to fit almost anywhere. Replacing the cable to the side instead of the back like it is at SI-2, the radar shortens even more.

K-Band AntennaDirectionalRS232 Serial PortStationary Mounted Radar Systems5-150mph (8-241 km/h) Speed RangeRange: 1, 500ft (457, 2m : default setting) 3, 000 ft ( 914, 4m : maximum range)Highly Customizable to Meet Customers Needs