Our Products
Our Complete range of products are Disintegration Test Apparatus, Dissolution Test Apparatus, melting point and ACCESSORIES FOR MICROPROCESSOR INSTRUMENTS.
Applied for determining the time of tablets, Disintegration Test Apparatus is equipped with a motorized shaft monde in and up 8 down direction at a frequency of 30 cycles per minute. 6 glass tubes of standard size with stainless steel wire gauge bottom can be held by it. Inside a 1 ltr. Beaker which is maintained at 30c by thermostatically controlled hot plates (without beaker); the cylinder makes upward and downward movement with standard dish.
Dissolution test apparatus on offer consists of water bath with 500 watt heater accompanied by digital temperature control, variable speed motors, with 30 m.m s.s shaft with digital r.p.m. meter, cylindrical glass vessel with the capacity of 1000ml and imported thick acrylic sheet along with transparent cover at top. the apparatus boasts a fine look due to the stirrer shafts of dissolution rate digital control panel.
nn
Dissolution Rate Test Equipment
n
Features :
MELTING POINT APPARATUS IS VERY USEFUL IN THE DETERMINATION OF THE MELTING POINT OF ANY SUBSTANCE IN SMALL QUANTITY UPTO 300 DEGREE C. IT CONSISTS OF AN ALLUMINIUM BLOCK WHICH ACCEPTS THREE CAPILLARY TUBES AND A MERCUTY THERMOMETER. THE BLOCK IS HEATED BY TWO ELEMENTS CLAMPED TO THE SIDES.
THE BUILT IN LAMP PROVIDES UNIFORM AND SHADOWLESS ILLUMINATION OF SAMPLE TUBE WHICH ARE VIWED THROUGH THE MAGNIFYING LENS AGAINST EITHER A DARK OR BRIGHT GROUND SELECTED BY ROTATING A KNOW TO THE REAR OF THE APPARATUS .
A BUILT IN A ROTARY THEOSTAT GIVES ACCURATE ADJUSTMENT OF THE RATE OF INCREASE OF TEMPERATURE AS MELTING POINT IS APPROACHED. BOTH THE HEATERS ARE KEPT 'ON' IN THE 'LOW' AS WELL AS 'HIGH' POSITION OF THE TOGGLE SWITCH, THUS ENSURING UNIFORM HEATING FROM BOTH SIDES OF THE BLOCK. A SECOND TOGGLE SWITCH ON THE RIGHT SIDE CONNECTS THE LAMP AND POWER INPUT TO THE APPARATUS..
(A) COMBINATION PH ELECTRODE (GEL FILLED) (B) D.O. PROBE(C) CONDUCTIVITY CELL (D) TDS CELL (E) STAND FOR SENSORS.