Our Products
Induction Cooktops, Gas Stoves & Burners
1 Products availableCoir & Agro Products
1 Products availableKitchenware And Cookware
1 Products availableTesting Equipment
1 Products availableSoldering Equipment
1 Products availableWater Heaters
1 Products availableElectronic Development Boards
1 Products availableInverters
1 Products availableOur product range contains a wide range of
This gadget can be used for heating / frying / cooking food using a 12V car / inverter battery.
Remember the electric heater which is used to make tea / cook food using 220V AC electricitythis is something similar, except that it uses 12V DC battery powerso no danger of electric shockhere the heating element & cooking vessel have been joined into one so the vessel cannot be dipped in water for cleaningalso while the 220V electric heater uses some 1000W of power this gadget uses 135W of poweralso cooking vessel depth is lower than expectedmay be just enough for few cups of tea / coffee or boil a packet of Maggi or fry an omelletethe sadest part is it is expensive at Rs 6, 499it should have been at Rs 649 for the poor Indian marketalso some car 12V cigarrete lighter sockets may not be able to support as it draws 13 Amperes so sepeate wiring may be neededalso the car / truck engine will need to be kept ON else it will drain the battery quicklyAnother use could be with the big 12V, 150 Ah batterylets us suppose there is power failure & LPG supply not available then u can cook using a 12V batterywith a 100W solar panel (Rs 6, 000-Rs 7, 000), a 12V 10A charge controller ( Rs 800) and a 12V 100 Ah battery (Rs 5, 000)total Rs 13, 000 this could be used for cooking for 7-8 hourscould also be used to boil eggs, bacon, hamburgers or heat packaged foods
This gadgets helps keep an eye of the energy levels of any 12V lead acid battery.
LED 1 11.5 0-50%LED 2 12.0 50-75%LED 3 12.6 75-100%LED 4 13.2 100% Full charged
Repair work often comes to a halt during power failurethis soldering iron works on a 12V battery supply.it uses some 30W of poweris designed for a long lifeso now even areas with a disturbed power supply can carry on their work using this soldering iron
This heating element can be used heating small quantity of water or any other liquid using a car or inverter battery or with a 100W solar panel
Features
Attention
This electronic circuit can be used with any sealed / flooded 12V lead acid battery to delay battery sulfation / ageing.it increases battery life by 2-3 timesits users also found that less water tops were required after this was used and battery temperatures did not rise high after it was employed.
It works by sending mild electric pulses into the battery thereby preventing sulphationto use simply hook the red wire to the positive terminal and black wire to the negative terminala red indicator starts flashing and the desulfator is now working on your batteryit stops automatically when battery voltage goes below 12.8V to prevent draining the battery completely as it uses some 60 milli AmperesA microprocessor precisely controls the pulses which break up the sulphation crystals on the battery plates, preventing sulphation from ever reducing the performance of the batteries.it is recommended to be used with new batteries but can also prolong life of used / in service batterieshowever, they cannot revive dead batteries
PRESET: A preset can be used to increase / decrease the operating voltage of the desulfatorif you want the desulfator to work longer esp on old batteries you can set it to 12.5V while if you would like to maintain high energy level esp for small and new battery then a 12.9V can be set by opening the cover behind and rotating a screw.
We have been selling this since the past 4 years and is supported by certificates from 17 customers who have given us in writing that this gadget has helped prolong the life of their lead acid batteries
Advantages of this desulfator:
1. No irreversible sulfation formation through out the battery life (if installed on new battery or within 4- 6 months ).
2. Battery will remain in peak condition.
3. Batterys internal impedance will be reduced.
4. The electrolyte temperature will be minimum.
5. Less or almost nil distilled water topping is required.
6. No boiling of electrolyte hence no acid fumes or smelling.
7. A sulfated battery requires more electricity for charging process. This is because of high battery impedance.
8. Guaranteed double battery life in normal conditions.
We do not claim that it is a remedy or substitute for below things:-
1. Periodic checking of water level.
2. Cleaning of battery terminals and coat of petroleum jelly.
3. Checking of inverter output (proper battery charging).
LIMITATIONS
1) Reverse polarity protection with a fusethe fuse in the wire of the circuit will get blown if by mistake you connect the black wire to the positive red terminal of the battery and red wire to the black negative terminal of the batteryso please connect it to the battery carefullyafter connecting it is recommended to permanently bolt the wires to the battery terminals
2) Not water proof If during car / truck cleaning process this circuit gets flooded in water it may get permanently damaged
tem Description: Convert DC 12V electricity source into AC 220V powerthis is not a pure sine wave inverterAlso it is not a battery chargerand it cannot charge a 12V battery
Widely used for all kinds of electric equipments which power consumption are less than 1000W and which voltage are equal to AC 220V, such as cell-phone, portable computer, electric light, digital camera, TV, CD player, DVD, electric fan, electric tool and so on.
How to determine what products are 1000W power?this can be seen from the specification mentioned on the gadgetfor example220V x 4.55 Amps = 1000W
USER REVIEW Worked on :
The desktop computer could power ON
The lights, fans and cooler worked fine
the 29 inch CRT color TV worked but black line disturbances could be seen
the 750W Press also worked
Did not work
1000W heating rod for heating water;
The fridge did not work as it needs pure sine wave and 5-6 times high surge current
1200W stone cutter also would power ON but trip when load was applied
It is made from advanced PWM CMOS chip, and can work in the state of ultrasonic sound, which diminish the bulk and weight and make the circuit work without noiseIt has a no load power of 10W when switched ONordinary transformer based inverters use 50-60W even without any load
Features:
Input voltage: 10.5-15 V DC
Output voltage: 210V 240V AC
Power rating: 1000W
On/Off switch control the fan
Automatic Thermal Shutdow
Overload Protection Automatically trips if demand for power is high and restarts