SM Adhesives

Khed, Ratnagiri, Maharashtra

SMAC RCCP-200  is oil base rust converter cum finish paint with special nano anticorrosive agent to protect steel structure from atmospheric corrosion.

Advantages :

• Self priming
• Rust converting
• Excellent penetration and rust converting  on oil contaminated surface
• Excellent performance even though poor surface preparation.
• Moisture tolerant and moisture release property after application of paint at the time of drying of paint excellent corrosion resistance ( 1000 hrs salt spray )moderate chemical resistant

SMAC Nanocoat is a highly concentrated polymer modified penetrant paint formulation for cementitious and mineral substrates. It forms a water repellent film over the substrate. No separate primer coat is required before subsequent paint coat. It acts to block capillaries in the substrate because of its penetrating chemicals & hence improves water resistant performance.

Advantages :

• No primer coat is required
• Eco friendly. Very low VOC content
• Prevents moisture absorption and dampness
• High coverage
• Alkali resistance
• Excellent hiding properties
• It forms a breathing coat over the substrate, hence low blistering n Can be used on previously water based paint coated surfaces n Prevents chalking of surfaces on which it is applied

Applications :

• Mildly damp and cured exterior and interior concrete surfaces
• Asbestos surfaces
• Pre-mixed mortar surfaces

Application Procedure :

• Clean all the the surface by removing loose matter, dust, dirt, algae, fungi, oily residues, previous paint residue, curing membranes etc and washing clean with water. It is recommended that the surface should be cured fully. Still, SMAC® NANOCOAT can also be applied on fresh surfaces.
• Repair cracks in the surface using cement : sand mix of 1:3 ratio or appropriate crack repair putty. Level the surface properly.
• Dilute SMAC® Nanocoat with potable clean water in 1:0.5 proportion and apply with brush or roller in a uniform manner as per coverage guidelines, as the first coat. This coat works as the priming as well as base coat for the surface. For better appearance, you can stain this coat using Acrylic paint stainer as per your shade requirement after dilution with water.
• Leave to dry and cure for at least 6 hours prior to over-coating.
• Dilute SMAC® Nanocoat with potable clean water in 1:0.5 (Paint : Water). Stain with Acrylic paint stain like Apex stains after dilution with water and apply over the previous coat
• Clean all the equipment & tools with plenty of water.

Care During Application :

• Always stir and filter the paint before use.
• Do not apply SMAC® Nanocoat below 12. C temperature and rains.
• Protect the area applied from rains and water splashes for at least 24 hours.
• Do not scratch or peel the primer.
• Do not thin SMAC® Nanocoat excessively.
• Do not extend the brush stroke excessively.