Shree Balaji Export & Co.

Rani Bagh, delhi

Determining of asphalt, cut bitumen and blown type bitumen.It consists of a bath thermostatically controlled with inlet and outlet taps. Fixed and movable brackets are so
Positioned that specimen is submerged in water throughout. The rates of pull of 50 mm/min. and 10 mm/min. are incorporated. A clutch arrangement is made to stop the movement of the movable bracket when rupture of the specimen is noticed. Suitable for operation on 230 volts, 50 cycles, single phase, A.C. supply. Complete with three moulds and plates supplied mounted on the apparatus but without thermometer.

For the measurement of the resistance to plastic flow of cylindrical specimens of bituminous pouring mixture loaded on the lateral surface. This is for use with hot mixture containing asphalt or tar and aggregate up to 25 mm maximum size.

For determination the workability of concrete provided the nominal maximum size of the aggregate does not exceed 38 mm. This is designed primarily for use in the laboratory but in suitable circumstances, it may also be used in the field. This test is more precise and sensitive and is particularly useful to concrete mixes of very low workability such as are normally used when concrete is to be compacted by vibration. Consists of two hoppers and a cylinder mounted on a rigid frame. The inside surfaces are machined smooth. The whole apparatus is furnished in hammertone spray. Complete with two trowels and a tamping  rod.

As per IS-516-Steel cube Mould 2.78 (7.06 cm) for vibrating machine complete with base plate.
Cast Iron Cube Moulds complete with base plate Size 5cm x 5cm x 5cm. -Cast Iron Cube Moulds complete with base plate Size 10cm x 10cm x 10cm.

Consists of a vibrator table resting upon elastic supports, metal post, sheet metal cone open at both ends, and a standard iron rod. The table is enquipped with an elecrically operated
Vibrometer mounted under it by an electric motor, both double ended shaft, working on 220 volts, single phase A.C. supply.
The steel cone is 30 cm high, with dia at the bottom 20 cm and at top 10 cm. A swivel arm holder is fixed to the base, into which is telescoped another swievel arm with funnel and guide sleeve. A graduated rod is fixed on to the swievel arm and at the end of the graduated armecords the slump of the concrete cone, and the volume of concrete cone after vibration of cone in the pot. Complete with electrical accessories.