Compressive Strength
The failure loads of mortar cubes can vary considerably according to the type of cement and the period of curing. However, a capacity between 50 kN and 500 kN encompasses the majority of test conditions. A 500 KN Compression Testing Machine is suitable for testing mortar cubes, cement mortar and pozzolana cubes of 50 mm. For details see under SCO-1040.
SCE-1003
Flexural Strength
4 kN Flexure strength Testing Machine,
Electrically Operated,
IS: 1727, 4031For the Transverse test of pozzolana and cement mortar prisms (Rilem Cembureau test) by single point loading of a 60 mm long prism supported at 100 mm centers. Smaller loads, less than 10 N, can be applied and measured with an accuracy of 1% in the upper four-fifths of the range.The load is increased at the rate of 40- 60 N/sec.Supplied complete with: Proving ring of capacity 4KN and Flexure Test Attachment.
Gauging Trowel
IS: 4031, IS: 5515
SCE-1004
Gauging Trowel, IS: 5515, 200 mm long blade Weight 210 10 g
SCE-1005
Gauging Trowel, IS: 4031, 150 mm long blade with straight edge. Weight 210 10 g
SCE-1006
Gillmore Needle Apparatus
ASTM C 91, C414, C266, AASHO T154For determining setting time of hydraulic cement. The apparatus consist of a base plate with a vertical shaft and two horizontal arms, the lower arm being adjustable for height. Supplied complete with one initial needle, one final needle and a base plate.
Replacement Parts
SCE-1006001
Initial Needle 1/12-inch dia. lb. wt.
SCE-1006002
Final Needle 1/24-inch dia. 1lb.wt.
SCE-1006003
Glass base plate
Jaw Crusher - Designed to speed-up crushing of aggregates, Ores, Mineral, Coal and similar materials
- Compact and rugged for laboratory and small production units
- Manganese steel jaws adjustable for 6 mm opening
- Supported with strong steel frame
SCE-1007
Jaw Crusher of 12
SCE-1008
Jaw Crusher of 6
The specification is as follows.1. Single Toggle Jaw crusher size 4" x 6".2. Motor 3 hp /3phase/415 volt/50 cycle.3. Jaws Speed 350 rpm4. Jaws 10-12 Mn steel.5. Bearing Bush type6. Feed size 25 - 30 mm7. Product Size 6-20 mm8. Capacity 200 - 250 kg /Hour
SCE-1009
Jolting Apparatus
IS: 10078, 1982The jolting apparatus consists of a rectangular table, rigidly connected by two support arms to spindle at a horizontal distance of 800 mm from the center of the table. The table can be raised and allowed to fall freely by a cam, which is connected to a motor. The cam rotates at a rate of 60 rpm. A stroke counter, fitted with micro switch, is provided, which stops the machine after 60 jolts. Locating pins are provided for mounting the mould compartments on the table. The mould, surrounded by the hopper, can be clamped rigidly to the table. Supplied complete with mould and hopper. Suitable for operation with 230 V, 50 cycles, single phase, AC Supply.
