SE-Test Lab Instruments (I) Pvt. Ltd.

Sarai Rohilla, Delhi

It consists of a small split cylinder forming a mould. On either side of the split cylinder. Two parallel indicating arms with pointed ends are attached. Supplied complete with two glass plates and a lead weight.

The moulds is split vertically into two parts. The mean internal diameter in within +/-0.2mm and height is within +/-1mm. The ends are machined to +/-0.05 . The base plate and top plate are machined flat to +/-0.03mm.

Made of Cast Iron / Mild Steel. The mould are made of 4 plates assembled together. Each mould is supplied complete with base plate. Faces are machined flat to 0.2mm. And finished in size to 0.2mm.

A set of three moulds as per IRC-SP-53-2002 made of brass /gunmetal with the shape, dimensions and tolerances. The ends B & B` are known as clips, and the parts A & A' are known as sides of the mould. The dimensions of the mould shall be such that when properly assembled it will form a briquette specimen having the following dimensions. Total length : 75 0.5 mm

A = 36.5 0.1 MMB = 30.0 0.1 MMC = 17.0 0.1 MMD = 10.0 0.1 MME = 10.0 0.1 MM

These are available in different sizes and are made according to Indian and British standards . For the metric size cube mould, the faces are machined flat to +/-0.2mm accuracy and finished to within 0.2mm. For the inch size moulds, the faces are machined flat to +/-0.01 inched to within 0.01in. All moulds are supplied complete with base plate.

A simple mould which is filled with the soil under test. This is then dried and the resulting decrease os length of the specimen measured is expressed as the linear shrinkage. It is 25mm Dia. x 12.5mm Height x 140mm Length

It is supplied complete with base. All parts are marked with the identification number for correct assembly. Each mould is individually verified in the dimensional tolerances, hardness, squareness, flatness & roughness. Size: 40.1 X 40 X 160 mm

Consists of mould 100 mm x 5mm. Deep and a glass base plates. Used to determine soundness of hydrated lime

For casting of cement briquettes for tensile strength tests. It is a two part split mould made of gun metal.
Two thumb screws facilitate easy and quick assembling and dismantling of the mould. The minimum cross section of the briquettes cast is 25.4 mm x 25.4 mm. Supplied complete with a steel base plate

Standards:IS 4031, 10086, ASTM C 227. & BS 1881.

Specification:Available Models:
SET-1012-A :Shrinkage Bar Mould - One Gang (One Compartment)
SET-1012-B :Shrinkage Bar Mould - Two Gang (Two Compartment)
SET-1012-C :Shrinkage Bar Mould - Three Gang (Three Compartment)
SET-1012-D :Shrinkage Bar Mould - Four Gang (Four Compartment)

Stainless steel smooth or knurled and threaded reference pins as required.Supplied in Packs of one dozen.