Saurashtra Systopack Pvt. Ltd.

Wadala, MUMBAI, Maharashtra

For bore & integrated shaft type Spur, Helical & Involute Gears, ZERO BACKLASH-DOUBLE FLANK CONTACT test principle (Meshing Force 1 Kgf, Constructed with graded seasoned CI Casting, Table Mounted, Electrically operated variable speed drive rotates component gear at optimized peripheral speed, PLC based on-line PC system using self standing our PC software to control machine operations, acquire-interpret-display test data, declare Accept Reject status, mark high spots and provide Accept mark for accepted component.

The equipment facilitates accurate and right angle cutting of specimen required for Ring Crush, Flat Crush, Substance, etc.

Rigidity of the fluted structure is one of the essential characteristics of corrugated board and this test is necessary to identify and measure the crushing resistance of the flute structure on the corrugator and other converting equipment.

The CMT permits the evaluation of corrugating medium before it is fabricated into combined board, and may also be used as a basis for judgement of fabrication efficiency.

It is most essential to make laboratory specimen of fluted strip of corrugating medium for conducting Concora Medium Test (CMT).

This equpment is designed to make laboratory specimen for accurate testing of medium on Crush Tester.

This equipment is extremely versatile for conducting a variety of tests, on different materials as per National and International Standards.

Scope

The Ubique Universal Testing Machine is designed to accommodate all types of Tensile and Compression based Test mentioned below as per the Various National and International Standards.To name a few test:

• Tensile, Flexural, Compression, Top Load, Torque, Co-efficient of Friction, Peel Strength, Seal Strength, Bending, Stiffness, Folding Endurance, Bond Strength

Introduction

• Ubique Universal Testing Machine (UTM) is available in 2 modelsA) Microprocessor b ased ModelB) Integrated Touch Screen Control PanelModel
• Both Models are available in 2 variantsA) Single Pillar and B) Double Pillar
• UTM is useful for testing various types of Materials and packaging like plastics, paper, wood and metals Various Compression and Tensile based tests can be performed in both - Dynamic & Constant Load or Length options
• Optional at extra Cost

  	Depending on requirements and the tests to be carried out, any of the attachment/s shown overleaf can be selected optionally and are supplied at extra cost.
  	Additional Load Cells of different capacities.
  	Higher admit than 500 mm, between the Platens, in multiples of 100 mm.
  	RS 232 Port.
  	** Higher Loading Speed can also be provided up to 500 mm/min.

This equipment measures and directly indicates substance of paper and paperboards in terms of grams per sq. metre. A must formanufacturers of paper, corrugated boards, solid fibreboards, shipping containers, etc., and for consumers/dealers of such packaging materials.

Salient Features:

• Direct reading of G.S.M. from small specimen of sizes: 10 cm x 10 cm or 10 cm x 20 cm or 20 cm x 25 cm
• Peak-hold facility
• Precise and reliable
• Sturdy in construction
• Very simple to operate
• Supplied with three templates

  10 cm x 10 cm; 10 cm x 20 cm and 20 cm x 25 cm

  Capacity

  	0 to 999 G.S.M.
  	0 to 3000 G.S.M.
  	Least Count : 1 G.S.M