Satguru Engineers

Sector 33, Gurugram, Haryana

'SATGURU' Levelling Jack can used as an adjustable support block for clamps and as a stopper or leveling block in fixtures or machines, as well as for levelling surface plates or other heavy duty work pieces. Its unique design does not allow the levelling screw to rotate while adjustment hence makes it suitable for fine level adjustment. It also has a heavier version of levelling jack with a heavy body and Levelling Screw & Knurled out. This Jack is specially designed for heavy castings & machines.

'SATGURU' Grinding Vice - Screw Type is also a precision machine vice. Body & Jaw made of tool steel, hardened, tempered & precision ground.
All hardened & tempered to 52-56 HRC.
All Sides Parallelism & Squareness within +- 0.005mm.
Inspection certificate is furnished.
Accuracy 5-10 Micron.

These Studs having threaded length of side B1 shown in figure below enables use on threaded platens of moulding machines or threaded beds of presses for longer insertion in the tapped holes. These studs also have a flattened middle portion for tightening & loosening with the help of an open ended spanner.

SATGURU' Precision Sine Vice - Screw Type is used to obtain precise angles by means of gauge blocks. Apart from its use on milling and grinding machine, this sine vice can also used as a reference for inspection.
1.All hardened & tempered to 52-56 HRC.
2.All Sides Parallelism & Squareness within +- 0.005mm.
3.Inspection certificate is furnished.
4.Accuracy 5-10 Micron.

STEP BLOCKS (Hardened & Tempered, Black Finish) 'SATGURU' Step Blocks are used as adjustable supporting Blocks at the rear of the clamp while clamping the work piece. Different heights can be achieved by using combination of two different size of Step Blocks. Available in pairs (Pair consists of 2 identical Step Blocks) Combination of two Step Blocks of same or different sizes is kept as support under one Strap Clamp. But in case of use of Step Blocks with Stepped Strap Clamp, only one Step Block of suitable size is kept as support under one stepped strap clamp.

'SATGURU' Steel Parallels are used as precision packing support under jobs or fixtures. Made from tool steel, hardened, tempered & precision ground in matched pairs. Matched pairs are marked with identical serial numbers. All sides are chamfered. Overall sizes are nominal.

'SATGURU' Adjustable Support Plates are used as adjustable supports at the rear of the clamp. It comprises of number of plates each 2mm thick hinged together. Desired height is achieved very easily by swinging aside the required number of plates and using the remaining as support block. Different models of support plates can be stacked on each other to achieve extra height.

These nuts have flanged face for larger face contact with the surface to be tightened on.

'SATGURU' Grinding Vice has body of one piece construction made of tool steel, hardened, tempered & precision ground. This vice can be used standing on its base, sides, end or top. Movable jaw is spring loaded for positive down hold & quick retreat. Due to downward pressure of jaw, job does not tilt while tightening in this vice. This vice can be used as a reference for inspection.

SATGURU' Precision Sine Vice - Screw Type is used to obtain precise angles by means of gauge blocks. Apart from its use on milling and grinding machine, this sine vice can also used as a reference for inspection.

1. Angles can be set in 3 dimensions. Swivels 360 0 around base. The vise can be elevated through 90 0 from the horizontal to vertical. And also can be tited on its lower angle base up to 450 in both right and left.
2. Tilting of any angle all keep the work piece stady, smooth.
3. Particularly the clamping part of screw is strengthened by a bush made of gunmetal.