Ryder Equipments P Ltd

Athipalayam, Coimbatore, Tamil Nadu

Ryder oil sight glass is a tabular sight glass. designed for the use to check the level of small tanks, sumps and reserviors. the gauge is a simple to fit and check the level in any angle.

Ryder Oil Level plug used to view the oil level in the pressurized tank. The oil level plug had a circular thick toughened glass with internal reflector. Wide ranges of plug sizes are available. This plug is suitable for high pressure and temperature. Oil level plug mostly used the screw compressor oil tank pressurized hydraulic tanks & vessels

Specifications :

Negative type regulator, the output pressure reduced based on the input. In this type butterfly valve is open always and when pressure increased more than 25Kg/cm2 pressure regulator will close.

Specifications :

This Solenoid Valve Manifold is used in the automobile vehicle to operate various functions in the vehicle. One valve is used in the exhaust brake system, another valve is to operate PTO and the third valve is used to the dipper operation. Three valves are mounted in a frame and the valves are operated independently based on the operator signal. The valves are 24V DC normally closed two positions three way valves.

Specifications :

Ryder Servo cylinder controls the step less positioning of the throttle valve (Butterfly or Fuel Injection Pumps). Due to Teflon rings and very low friction between spindle guidance, the motion is a juddar free motion. This cylinder is rear mounted and the spindle travels up to 40mm. This cylinder is used up to 5 kg/cm Servo pressure

Specifications :

Inflator gun is used to inflate, deflate and check the air pressure in the tyre.

Models:

• C type: Used for two wheelers and four wheelers
• D Type: Used for all type vehicles including trucks

Ryder Air gun is suitable for all industries.The air gun is madeup of aluminium body with build in control valves and a hangup hook, Advantages Materials Attractive Design body- Aluminium Max.Flow Tube -Steel Zinc Plated Low Noise Level Valve - Brass Seals Nitrile Rubber spring - Spring Steel.

Ryder Oil sight glass is a tubular sight glass. Designed for the use to check the level of small tanks, sumps, and reservoirs. The gauge is a simple to fit and simple to check the level in any angle. The gauge is protected by a polycarbonate plastic glass guard tube over the sight tube. The end plug screwed with the vessel connections are sealed to the sight tube by a unique O ring gland system to ensure ease of installation and trouble-free operation. The system will allow for adjustment of gauge 2mm in the fitting centres.

Specifications :

We make suction control 3" and 4" size suction controller inlet. Ryder suction controller controls the compressor capacity. At start up the valves open until a control signal is applied to close the valve. During normal operation the valve opens and closes in response to the control signal to meet the down stream air demands. As shut down a check valve stays closed to prevent back through the compressor.Features of Suction Control Valve:Straight through design for low pressure drop.PTFE valve seat for tight sealOne piece housing with square flange mountingSide ports for pressure tapsOperating pressure up to 200psiFlow up to 500cfmSample Availability : YesSupplier Product Code : 01

Ryder throttle cylinder controls the step less positioning of the throttle valve (Butterfly or Fuel Injection Pumps). Throttle cylinder accomplishes a juddar free motion. This cylinder travels up to 50mm. This cylinder is used up to 4 kg/cm' pressure

Specifications :