Re Shape Meditech

Interbody cages aim to improve the stability and balance of the treated spinal segment, while also relieving pain and restoring function. The goals of spinal cages include .

• Restoring the height provided by the original intervertebral disc .
• Supporting the front (anterior) part of the spinal column .
• Expanding the bony openings between the vertebrae (foramina), providing more space for spinal nerves .
• Restoring the normal lordotic (S-shaped) curve of the lower (lumbar) spine
• Transferring loads from the upper segments to lower sections of the spine
• Promoting a solid fusing of the adjacent vertebral segments by promoting bone growth
• Increasing the spaces within the spinal canal to decrease the compression of neural tissue that may be indirectly compressed

• Platesavailable holes are 6, 7, 8, 9, 10, 12, 14, 16, 18 and 20.
• Platehas combi holes and round holes. Combi holes allow fixation with locking screws in the threaded section and cortex screws in the dynamic compression unit section for compression.
• The shaft holes accept 5 mmlocking screwsin the threaded portion or 4.5 mmcortical screwsor 5 mm Lockingcancellous screwsin the compression portion.
• The symmetrical shape of the plate holes enables compression to be achieved in both directions.
• The hole spacing in the plate is regular. Plate positioning is thus not restricted by the presence of a mid-section. This is of particular advantage in comminuted or segmental fractures.
• 4.5/5 mm Locking Narrow Plate allow implant placement to address the individual fracture pattern.
• Limited-contact surface reduces bone-to-plate contact and helps to preserve the periosteal blood supply.
• Choice of different lengths of plate eliminates the need to cut plates.
• Pre-contoured plate to match anatomical shape.
• Available in both Titanium and Stainless steel.

Available in 5, 7.5, 10, 12, 15, 17.5mm
the implants specifically designed for medial opening wedge HTO, Puddu plates are most commonly used. This plate is fixed to the medial side of the tibial plateau, and a spacer is inserted into the osteotomy gap, thus preventing gap closure. However, some authors have reported high failure rates of this implant and technique in HTO due to unstable fixation11, 18). For these reasons, a new implant with a long, rigid titanium plate (TomoFix) with the curvature of the medial tibial metaphysis was designed for opening wedge HTO.

The cannulated ratchet handle allows the passage of screws while keeping the axis using a guide K-wire.

Its footprint allows the use of taps or drill bits during surgery.

Can be combined with the TorxPlus or Hexagonal rods to fit interference screw heads.