Rashtriya Electrical and Engg. Corp.

Tronica City, Ghaziabad, Uttar Pradesh

Excellent anti-pollution performance, suitable for high polluted area, Free of cleaning, economical maintenance and suitable for difficult maintenance area, No need of zero value check , Light weight, easy and economical to transportation and installation , Not brittle, and reduce the purchasing quantities for spare parts.

We have a long history of manufacturing, supplying and distributing to our clients quality and standard Cut Out Fuse that ensures full-fault-spectrum protection for overhead distribution systems. Manufactured with advanced technology and premium quality materials, the Cut Out Fuse can be extensively used in commercial and residential areas. Whether applied on capacitors, overhead transformers, lines or cables, they work well and avoid any type of unwanted incidents. At Rashtriya, we design cutout fuse with silicone, porcelain, or polymer concrete insulators. The silicon rubber and polymer concrete cutoutshave the ability to perform in stressful environments, including extreme heat, cold, by the sea coast or in a heavy polluted area.

Reliability is the most important property of an insulator whether it is a polymeric (composite) insulator or ceramic one. The reliability of an insulator depends upon its electrical and Polymer Line Post Insulators mechanical strengths. With the advent of modern manufacturing, mechanical molding and fixture technique

Ruled over the market till late second half of the 20th century. The polymeric insulator has a fiber rod structure covered with weather resistant rubbers and fillers and fitted with end fittings. Such a type of insulator is also called composite insulator. The most critical thing to be considered in outdoor insulators is the interface between the solid insulting body and the surrounding air. The problem appears at the interface because it is the interfering point of air and the solid insulator. This problem arises due to the effects of pollution, rain, dust, salt, corona, arcing over surfaces, nitric acid in air, etc. These things increase the leakage current and deteriorate its performance. Surfaces of insulating bodies were therefore coated with glazed material for glass and porcelain insulators, and organic or semi-organic polymer rubbers for composite insulators. A typical composite insulator is composed of a glass fiber reinforced (GFR) epoxy or polyester core (rod), attached with metal end-fittings. This is the load bearing structure. GFR plastics are mechanically very strong but are not able to bear the outdoor environmental effects. The presence of dirt and moisture in combination with electrical stress causes the material to degrade by tracking and erosion. So the rod is covered by a coating that protects it from outside stresses such as rain, salt, fog, pollution, etc. This coating is referred to as housing. A housing material should be able to protect the load-bearing core and provide sufficient pollution with stand. The reason of use of rubbers instead of ordinary plastics is simply the fact that the housing must be flexible enough to follow the changes in dimension caused by temperature or mechanical load. The early developments of modern polymeric insulators started in 1964, and prototypes for field installations started in 1967, and a report from 1996 stated that insulators installed in 1969 were performing well.