ultra brand rectangular block used for grinding, light milling, drilling & inspection of round & square jobs, accuracy for parallelism is within0.015mm provided with on-off switch except for 1" block .more...
Transfer blocks used as an accessory for magnetic chuck to clamp thin & odd shaped jobs. Maximum flux transformation when placed parallel to pole lines. perfectly ground within 5 micron & supplied in matched pair.more...
MRM – 475, 475 H, 575, 575H, 676, 676H, 856, 856H, 876, 876H, 976, 976H These Magnetic –Vee blocks are invaluable and versatile in tool – making and inspection, in quality control and tool – room. Due to their extremely high magnetic power they can be usedmore...
These blocks are designed to hold the steel components in desired fixed position during welding marking grinding etc. These are extremely useful in Tool – Room in the assembling of jigs and fixtures and are also utilized with Sine table for inspection of components. They are almore...
Ground with parallelism, flatness, and square ness within 5 microns. These blocks have no magnetism but when placed parallel to poles of chucks, they transfer magnetic power to top and sides for holding. Available with V shaped face for holding round jobs. One pair of blocks is fmore...
'V’ Blocks are required for Quality Control, Tool Room and Standard Room. "Crystal" Brand Magnetic 'V’ Blocks have high magnetic pull, hence they can be used fro drilling and grinding (both wet and dry) and even for light milling work. more...
The 'V’ Block have two 'V’ angles of different sizes to take jobs of various dimention. By means of clamp the work can be held rigidly to the 'V’ Block. The top 'V’ and bottom 'V’ are parallel within ± 3 micron and it's squareness to the end faces and height variation more...
Use and Application Used to hold round ferrous rods for performing drilling or grinding operations. They consists of a rectangular block with 90° channel rotated at 45° from the sides forming a V shaped channel. The permanent magnet holds the work firmly and the blocks homore...
Details : Standard models are made with steel and aluminium lamination secured by rivet rigidly. Can be made with brass lamination on request. Special sizes are manufactured on order.more...
The 'V’ Block have two 'V’ angles of different sizes to take jobs of various dimension. By means of clamp the work can be held rigidly to the 'V’ Block. The top 'V’ and bottom 'V’ are parallel within ± 3 micron and it's squareness to the end faces and height variation more...
MagTech Magnetic ‘V’ block’ is basically a clamping device. Hence, it is used in Standard Room Tool Room and Shop Floor also for Drilling, Grinding Light Milling operations. The 'V’ Block has a total three magnetic surfaces. Top, bottom with 90 degree angle and end surfacmore...
HARDENED AND GROUND MAGNETIC V BLOCKS • All sides are hardened & ground • Used for grinding, light Miliing, Drilling & inspection of round & square Jobs. • Accuracy for Flatness, squareness & parallelism within 0.005mm upto 150L & 0.010mm for 200L • Hardness 60 ± 2 RC. more...