Waste Refinery Plant

Listing ID #1695453

WyunaSep Hydro cyclone separators are one of the best ways to separate two non-mixing liquids. Almost any hydrocarbon oil and most non-hydrocarbon oils such as corn, orange, or other vegetable oils may be separated from water in a satisfactory manner. We manufacture our Waste Refinery Plant, as per the leading industrial norms and standards.

High Performance :

• WyunaSep liquid /liquid hydro cyclones can treat emulsions with oil droplets below 15 microns. (50 to 100 microns for competitor's systems)
• The most reliable oil separation performance. Units are not affected by debris build up or inadequate maintenance, as can occur with other systems.
• The treatment system is closed hence there is no equipment smells or vapour emissions.

Low Maintenance :

• No plates, or Hopper to clean leading to lower yearly maintenance costs.
• No closely packed plates to block.
• No algae chemical dose required. No large stagnant volumes.
• All our systems use high quality stainless steel piping and frames.
• No occupational health & safety issues like with plate pack cleaning.

Easy Installation/Use :

• Our most models are easily manoeuvrable and will fit into confined or hazardous spaces.
• Pressurized oil and water discharge allows flexibility in site location and savings because re-pumping is not required.
• Standard systems are fully pneumatic with no electrical connections. This greatly simplifies and reduces the cost of installation.

Operational Flexibility :

• Has the ability (via recycle option) to batch treat very difficult emulsions, and discharge water when oil content is below limits. With low cost recycle option, equipment has the ability to meet future oil discharge limits without additional capital expenditure. Removed oil is stored in large above (or below) ground decanting containers, extending the time between oil waste collections. Because our systems use skimmers, oil layers do not accumulate in the effluent pit so little or no oil will escape if the pit accidentally floods.

Specifications :

• Separate oil from wastewater as an industrial pre-treatment system prior to directing the water to sewer or other disposal.
• Separate oil from circulating water or other aqueous phase systems to remove the oils so that the stream can more economically be reused or so that the oil in the water stream does not cause problems elsewhere in the system by fouling heat exchangers or catalysts.
• Separate oil from water so that the water may be purified and reused or recycled.
• Can be used either internally in chemical plants or oil refineries or in plant or refinery outfall streams.
• Industrial pre-treatment of waste streams prior to disposal to sanitary sewer systems

Features :

• Foot Print - Compact, 10% the size and weight of conventional systems. -2 to 24 m3 = 1 to 1.5 m2 area.
• Oil content – single cycle <20 ppm or recycle + DHRR <5ppm in two stage
• Clean water with no chemicals.
• Effluent can be recycled for continuous treatment.
• Lowest cleaning & maintenance bills.
• Lowest repair & parts replacement bills.
• Lowest total ownership cost over 2 to 4 years.
• Ensure discharge compliance.
• Satisfies Regulatory authorities.
• More likely to meet tougher new Regulations.
• You can get on with your business.
• Fully pneumatic.
• Complies with Standards for hazardous Waste Zones.