UNICON Kaplan Turbine Test Setup

Listing ID #1606792

We are offering kaplan turbine test setup
description:-
kaplan turbine is an axial flow reaction turbine named in honor of dr. B. Kaplan, a gennan engineer. This turbine is suitable for low head. The power produced by a turbine is proportional to qh. As the head (h) decreases the j discharge (q) must increase to produce the same power. The present set-up consists of a scroll casing housing a runner. Water enters the turbine through the stationary guide vanes and passes through the runner axially. The runner has a hub and airfoil vanes, which are mounted on it. The water is fed to the turbine by means of centrifugal pump. The runner is directly mounted on one end of a central ss shaft and other end is connected to a brake arrangement. A transparent hollow cylinder made of acrylic is fitted in between the draught tube and the casing for observation of flow on to the airfoil vanes. This runner assembly is supported by thick cast iron pedestal. Load is applied to the turbine with the help of this brake arrangement so that the efficiency of the turbine can be calculated. The set-up is supplied with control panel. A draught tube is fitted on the outlet of the turbine. The set-up is complete with guide mechanism. Pressure and vacuum gauge are fitted at the inlet & outlet of the turbine to measure the total supply head on the turbine.
Experiment:-
• to study the operation of a kaplan turbine
• to determine the output power of kaplan turbine
• to determine the turbine efficiency
utilities required:-
● water supply and drain. ● electricity 15 kw, 440v ac, three phase
technical specifications: -
model hm 109 (1.33 hp) hm 109 (5 hp)
output power 1.33 hp 1 kw 5 hp 3.75 kw
discharge 1500 lpm (approx.) 5000 lpm (approx.)
supply head 5 m 5 m
rope brake dynamometer dia 200 mm dia 300 mm
sump tank capacity 300 liters. capacity 600 liters.
Water circulation centrifugal pump capacity 7 hp, three phase capacity 20 hp, three phase
speed 1500 rpm (approx.)