Turbine Pump

vertical pumping applications require the units be available in a variety of pumping configurations to meet user needs. Fairbanks Morse meets these demands by providing pump bowls from V-6,V-8,V-10 in diameter. Turbine bowls can be staged in series to produce the necessary discharge pressures.Materials of construction include cast iron, bronze, stainless steel and G.I Pipes or other machineable materials. Wear rings are available to provide a renewable surface.Open line shafts allow the product to lubricate the shaft bearings. Enclosed line shafts can provide external water flush, oil, or grease-bearing lubrication. Threaded or flanged column and line shaft assemblies are available in both short and deep-set applications.Drive shafts extending through the discharge head can be sealed using either packing or mechanical seals. A wide range of mechanical seal designs are available along with an assortment of packing box designs, including those for high-pressure applications. Fairbanks Morse also offers an array of discharge head designs, including cast iron or fabricated steel construction, above-or below-ground discharge, and flanged or plain-end discharge connections.Vertical turbine pumps can be driven by vertical monoblock motors, vertical solid-shaft motors, or through right-angle gears by an internal combustion engine, steam turbine, or horizontal motor. operate with gas kate and wind-mill.When vertical monoblock drivers are used, impeller-to-bowl clearances can be maintained with an adjusting nut located at the top of the driver. When vertical solid-shaft drivers are utilized, impeller clearance is regulated with an adjustable coupling.