Listing ID #3892226
Company Information
Ask for more detail from the seller
Contact SupplierFeatures:
Availabe Sizes:
TYPICAL APPLICATIONS
DRIP, TRACER: The FS600 Thermodynamic stream trap is commonly used as a drip trap on steam mains and steam supply lines. Supplied with integral Strainer and these traps can be used on tracing applications; however, thermostatic traps are normally recommended for this service. Ideal for outdoor application that Are subject to freezing and for superheated steam conditions
HOW IT WORKS
The thermodynamic trap has cyclic on-off operation with a disc that is pushed open by incoming condensate and closes lightly when steam tries to escape.
FEATURE
SAMPLE SPECIFICATION
The steam trap shall be all stainless steel thermodynamic type with hardened integral seat and disc with integral strainer.
INSTALLATION
Trap can be installed in any position; however horizontal is preferred. Installation should include isolation valves. Do not weld or damage can occur to the seat area.
MAINTENANCE
If trap fails, close isolation valves and remove cap. clean disc and seating surfaces and replace cap and disc with grove side toward seat.
Model |
FS600 |
Sizes |
1/2" , 3/4" , 1” |
Connection |
NPT & BSP |
Body Material |
Stainless steel 410 |
Optionsc |
Insulation Cap |
PMO Max. Operating pressure |
600 PSIG |
TMO Max, operating Temperature |
750°F |
PMA Max allowable pressure |
915 PSIG up to 250°F |
TMA Max. allowable Temperature |
610°F @ 750 PSIG |
Dimensions:
SIZE MM |
A (MM) |
A (MM) |
A (MM) |
A (MM) |
3/8 |
79 |
53 |
44.2 |
47 |
1/2 |
79 |
53 |
44.2 |
47 |
3/4 |
79 |
53 |
44.2 |
47 |
1 |
87.5 |
55.7 |
47.1 |
47 |