Solar Snake Repeller

Listing ID #4372645

A device powered by solar energy, making use of ultrasonic waves to repel harmful rodents (snake, etc.)
By emitting ultrasonic waves, the solar snake repeller drives away underground rodents and reptile very effectively. The ultrasonic waves will irritate them, simulate danger, and repel them away from the irradiated area. Ultrasonic is divided into five frequency models, they are 30 seconds. 35 seconds. 40 seconds. 50 seconds, once happen 4 seconds of Di. Di sound, in turn cycle work. Snake repeller LED lights when the solar panels charging or have light it will automatically close. When the solar panels do not charge or night time the LED light automatically open. After open the LED light, it will divided into two modes: keep lighting and flashing (every time for 30 minutes)., the solar snake repeller is effective within an area of 650 sqyare meters.

The Solar snake Repeller radiates in all directions. Avoid any obstruction and let the ultrasonic waves be emitted freely. To make the best use of the product, we strongly recommed an installation of 2 devices at every 30 meters for ground areas frequented by rodents.

The Solar snake repeller;s power is supplied by a solar cell, a rechargeable accumulator collecting power for operation at night. When the accumulator is fully charged, it can supply enough power for the dark house, thus ensuring a continuous around-the-clock operation.

Technical data:
Power supply: solar energy cell, or long-effective Ni-Card cell recgarged by solar energy. Frequency:400HZ-1000HZ

Please note:
Firslty, please check the ground surface before using it.Frozen soil, irrigated or waterlogged ground is not suitable. Diga hole into solid earth to place the device. The density of the soil will greatly effect the effectiveness of the device. The more solid the earth, the better the device will be functioning.

Please remove the protective notch (shown in fig1). No hammer should be used in installation. No excessive force should be applied lest the device be damaged.

Installation:
1. Connect the two connectors inside the aluminum bar onto the joints on the top and make sure that the colors of the joints shall match: red with red, and black with black(please refer to the following illustration)
2. Fix the bar and the top together.
3. Insert the bar into the earth, be car eful not to use excessive forve lest the device be damaged, or bump into any obstruction. The base of the top shall be exposed to the outside, about 1cm above the ground.

NB : Electrical products contain harmful substances for health and environment. Batteries should never be thrown away or incinerated but disposed of in accordance with the local regulations concerning chemical waste. Bring it to the nearestr collecting place. The product constitutes the applicable product according to the WEEE and ROHS directives; when discarding the unit, comply with local rules or regulations.