SilicoCrete TRG Premixed Mortar, Packaging Size : 25 Kg Per Bag

SILICO Crete TRG is a high-performance Gun Grade Premixed Mortar designed for effective filling of Tie-Rod holes and Wall Tie opening of shuttering technology. The product is designed to flow and travel and yet remain cohesive when filled by hand or by machine while being filled into the tie-rod hole so that the entire mix is filled inside hole without excessive oozing out from the other end. SILICO Crete TRG meets the requirements of GreenPro Ecolabel and qualifies as Green Product. 

Benefits:

• Single pack system with just the addition of water
• Flows yet remains cohesive for effective filling of Tie-Rod Openings
• Drying Shrinkage Compensated
• Plastic Shrinkage Controlled with Fiber Reinforced
• Early Strength gain
• Good Bond to Base Concrete
• Sufficient Paste to get comparable surface finishing matching surrounding Concrete
• Sufficient Cohesiveness to enable using Small Pumps for faster turnaround of filling work.

Method of Application:

• Clean the Tie Rod/wall tie holes/gap / opening to be filled and remove loose unsound concrete particles, dust, oil, paint, grease, waterproof coating etc. from the entire hole/gap and gap/hole should be free of all contamination which hinders adhesion
• 2Saturate the substrate with water to prevent absorption of water from the mixed material by flushing water inside the holes to be filled.
• 3Add around 80% to 85% of the predefined amount of water in the mixing vessel to SILICOcrete TRG powder slowly under continuous mixing. Preferably use a slow speed mixer. Keep mixing for 2 minutes. Add balance quantity of 15%-20% of mixing water and again mix for another 2-3 minutes to form homogeneous, uniform consistent workable mix.
• 4Now fill the Cement Mortar Caulking/Grouting Gun with the above prepared Silicocrete TRG workable mix fully and use a suitable Nozzle provided with the Gun which will exactly be compatible Tie Rod opening.
• Start filling the Tie Rod/Wall Tie holes with the above workable mix of SILICOcrete TRG from one end by applying required pressure using Cement Mortar Caulking/Grouting Gun till the mix travels smoothly throughout the hole by filling entire space in the hole and is seen reaching the other end of the hole without excessive ooze-out from the other end.
• Now remove the Gun from the first end and finish both the ends perfectly using flat thapi so that both the ends are level in line with the parent surface.
• The above same procedure should be followed for filling all other Tie Rod / Wall Tie holes.
• The Silicocrete TRG Mix should be used within the prescribed pot life.