Rust Preventive Oil, Form : Liquid

Listing ID #5331809

Frank Rust Preventive  Oils are solvent deposited water displacing type. Most of the oils can be applied directly to water wet metal surfaces whereby they displace water leaving a protective film.They can be applied either by dipping or by spraying. Oil layer can be removed by soaking in solvent like kerosene / mineral turpentine oil or by alkaline degreasing or solvent degreasing Frank clean R.P.grade. Rust Tech 1901, WD1902 and WD 1904 comply to IS:1154 specification and Rustech 116B Complies to IS:1674 specification.

​

FRANK RUSTECH WD 1901:

This is intended for severe conditions and leaves a greasy film, resistant to handling and giving excellent protection.  Can be used for protection during storage of valuable machine tools and as a final protective for tools and machined components.

FRANK RUSTECH WD 1902:

This grade gives a soft, tacky, oily film with excellent mechanical strength which can  withstand further handling . Can be used for products of high degree of finish in manufacturing of machine tools, fasteners strips etc. , providing excellent resistance to salt spray and hence can be used on components to be freighted by sea.

​

FRANK RUST TECH WD 1904:

This oil is used for items/components/ fasteners which are to be immediately wrapped by wax paper. Can also be used in inter operational protective for removal of soluable oil.

FRANK RUST TECH WD 1908:

This grade is a excellent dewatering fluid leaves a very thin oily film with little protective properties. Suitable for non ferrous metals like aluminium, aluminium alloys and brass to displace water and prevent tarnishing. Oil film can easily be removed by wiping.

​

FRANK RUSTECH WD 1950:

This is a water displacing type fluid to apply on metal surfaces to displace water. In short this is not providing any protective film. This dewatering fluid is to be applied by dipping.

FRANK RUST TECH WDX 130:

It gives very thin film which has very good rust preventive properties. Can be used for inter operational protection, live mechanism, gauges, micrometers, bright steel components and finished packing of bearings providing reasonable protection for indoor and outdoor.

​

FRANK RUST TECH WDX 132:

This grade is a solvent based water displacing fluid suitable for severe environmental conditions and long term protection. Suitable for treatment prior to storage of machine tools, cam shafts, crank shafts, circular saws, large gear, exposed sliding surfaces lathe blades etc. Providing indoor and outdoor protection.

​

FRANK RUSTECH 116B:

This provides water displacing heavy soft tacky film for protection on steel tubes, bars, wires , bare sheetings, wheel rings, auto parts and machined components. Protective film can be removed by wiping with rags soaked in solvents or a by alkaline degreasing.

​

FRANK RUST TECH 114:

This grade provides a hard yellow / red transparent varnish like tacking film. This oil dries in 30-40 minutes and fully in 8-10 hrs. Suitable for protection of cam shaft, crank shaft, cylinder liners, shackle pins, piston pins, gears, springs, taps, dies nuts and screws, hand tool, steel Rod and bar etc.