Manual Reset Mode : When preset count is reached the relay status is
changed. Counting stops at the preset value. To start the counting from
zero, press switch 'E' on the front paneI. The counter resets to '000000'
and starts counting. Here resetting is done manually.
2. Auto Reset Mode: When preset count is reached the relay status is
changed. Counter will reset automatically to '000000' after a specific
preset time & start counting again. Resetting is automatic. The time for
which relay status should remain unchanged is settable
3. Up Down Mode: In Up Counter, counting will start from '000000' and
increment by one digit for every input pulse. In Down Counter, counting will
start from the PRESET value and decrement by one digit for every input
pulse. Down Counting will not count below zero.
4. Relay ON OFF Mode : The status of relay can be selected ON OFF
during counting.
5. Division Factor Mode: This mode is to set the division factor.
Eg: Suppose division factor = 4. i.e. count will increment after every 4 input
pulses.
6. Selection of Speed :This mode is to select slowfast speed

Manual Reset Mode : When preset count is reached the relay status is
changed. Counting stops at the preset value. To start the counting from
zero, press switch 'E' on the front paneI. The counter resets to '000000'
and starts counting. Here resetting is done manually.
2. Auto Reset Mode: When preset count is reached the relay status is
changed. Counter will reset automatically to '000000' after a specific
preset time & start counting again. Resetting is automatic. The time for
which relay status should remain unchanged is settable
3. Up Down Mode: In Up Counter, counting will start from '000000' and
increment by one digit for every input pulse. In Down Counter, counting will
start from the PRESET value and decrement by one digit for every input
pulse. Down Counting will not count below zero.
4. Relay ON OFF Mode : The status of relay can be selected ON OFF
during counting.
5. Division Factor Mode: This mode is to set the division factor.
Eg: Suppose division factor = 4. i.e. count will increment after every 4 input
pulses.
6. Selection of Speed :This mode is to select slowfast speed