Rod Ends

Product features:

• Set of four
• Chloroprene rubber dust cover improves boot durability preventing premature failure
• ED coating process conforms to the end of life directive
• High specification grease and ball pin angular movement matches OE specifications for durability even in extreme road conditions
• Coated nylon ball pin seat provides smooth movement of the joint with a rotational torque to OE specifications for long lasting service
• Anti - corrosive protection applied to all products

1. Insert rod end  in a 10 mm nut. (This nut is used to lock  POS10 with tie rod so that it doesn't loose due to any kind of vibrations or otherwise)
2. Now tighten POS10 on one end of tie rod and pass it through 10 mm bolt using washer, Letting it through eye ball of POS10 tight it with lock nut. (Use washers on both side of eye ball of rod end)