Preheat flames are used to heat up the surface of the steel to approximately 1000�C (1800�F � bright red color) but below the metal's melting point. A jet of pure oxygen is then directed toward the heated area in a fine, high pressure stream. A vigorous exothermic chemical reaction takes place between the oxygen and metal forming an aluminum or iron oxide or rust. The pressure of the jet of oxygen blows away the slag or oxide forming a cavity. The preheat and oxygen stream are moved at constant speed to form a continuous cut.

The Main Terminology relevant to Oxy-Fuel Cutting is the following:

1. Preheat Flame
2. Oxygen Stream
3. Torch and Cutting Nozzle
4. Cutting Speed
5. Material Being Cut

The answer is that it cannot! This depends on the melting point of the individual metals oxides. Only metals whose oxides have a lower melting point than the base metal itself (low carbon steel and some low alloys) can be cut with this process. Otherwise as soon as the metal oxidizes it terminates the oxidation by forming a protective layer.

The Oxy-fuel gases used include oxygen, acetylene or liquefied petroleum gas (LPG); last two provide the high temperature Preheat flame.

Preheat flames are used to heat up the surface of the steel to approximately 1000�C (1800�F � bright red color) but below the metal's melting point. A jet of pure oxygen is then directed toward the heated area in a fine, high pressure stream. A vigorous exothermic chemical reaction takes place between the oxygen and metal forming an aluminum or iron oxide or rust. The pressure of the jet of oxygen blows away the slag or oxide forming a cavity. The preheat and oxygen stream are moved at constant speed to form a continuous cut.

The Main Terminology relevant to Oxy-Fuel Cutting is the following:

1. Preheat Flame
2. Oxygen Stream
3. Torch and Cutting Nozzle
4. Cutting Speed
5. Material Being Cut

The answer is that it cannot! This depends on the melting point of the individual metals oxides. Only metals whose oxides have a lower melting point than the base metal itself (low carbon steel and some low alloys) can be cut with this process. Otherwise as soon as the metal oxidizes it terminates the oxidation by forming a protective layer.

The Oxy-fuel gases used include oxygen, acetylene or liquefied petroleum gas (LPG); last two provide the high temperature Preheat flame.