Listing ID #2544552
Company Information
Ask for more detail from the seller
Contact SupplierApplication
To ensure very low humidity levels inside the generator and improvement in installation also enhances prevention of stress and corrosion rotor retaining.
Operation
The system comprises two heat exchangers. the hydrogen shell and lube type called precooler in which temperature of hydrogen reduces around 25⁰C to 30⁰C the cooled hydrogen now enters the second heat exchanger named evaporator further cooling up to 0⁰C to 3⁰C is accomplished in this H₂. the set dew point is adjustable. the cooling coil inside the evaporator have propelled through a refrigeration system due to low temperature in evaporator the moisture in the H2 condenses and converts in water from the water is collected in a well protected condensate collector and can be drained out when desired leaving the evaporator H2 again travels to pre cooler where it has dual functions of cooling the input H2 and outgoing leaving dry H2 is again rises to a safe tem H2 of around 25⁰C to 40⁰C before entering the generator to reduce stress on the system
Advantage of Jindal Refrigerated H₂ gas Driers over Conventional Driers
Hydrgen gas flow rate | 40-120 nm³/hr |
---|---|
Temperature of h2 gas at inlet : | 60°c max. |
Temperature of h2 gas at outlet : | 30°c nominal |
Pressure of h2 gas at inlet : | 05 kg/cm2 |
Compressor capacity : | 3225 kcal/hr (min.) |
Design pressure : | 10 kg/cm2 |
Dew point at evaporator : | 3°c to 5°c(adjustable) |
Flange connection : | Nb50 |
Power point at evaporator : | 415 vac 50 hz-3ᶲ |
Design for max. Ambient temperature : | 60°c |
Dimension of the system : | As per drawing |
Total pressure drop in drier h2 circuit : | 8 mm wg. |
Power consumption : | 2.5 kw (max) |
Colour:shade : | As per requirement |
All fillet welds : | 100% dpt tested |
Diemension in the system : | As per jindal drgawing |
DUE POINT SENSOR/DISPALY ALSP PROVIDED AS PER CUSTOMER REQUIRMENT.
Our consistent approach towards delivering superior quality in our products has enabled us to manufacture products that meet the requisite international standards like IS:2848:86, BS: 1904:84 & IEC-584 (IS:2054).
Our Company also registered with ISO 9001:2015 & CE Certification.