Stainless Steel Permanent Magnetic Drum Pulley

Features

• The magnetic pulleys can be installed easily at conveyor discharge
• They give complete magnetic protection over the entire face of the pulley for removing ferrous contaminants
• For different conveyors the magnetic pulleys of different sizes are available
• The pulleys either use ceramic magnets or powerful rare earth magnets

General Specification

• Flux density: 8500 ± 200 gauss
• Maximum operating temperature 450?C
• In all pulleys, best grade St. Ferrite/Rear Earth magnets are used for construction. The outer face and the end plates of the magnetic pulley are made out of stainless steel
• The magnetic pulley removes contaminants like nuts, bolts, wire, tools etc.
• It protects equipment, and product from the hazards of tramp iron

Types

• High Intensity – (NdFeb Magnet – 8500 Gauss)
• Low Intensity - ( Ferrite Magnet - 3500 Gauss)

Customized Pulley Designs
Shree Vishwakarma Magnets also makes custom designed Magnetic Pulleys to precisely fit customer’s application. Following information is required:
Type of material

• Conveyor belt width
• Belt Speed
• Size and concentration of the contamination
• Burden depth

Installation
Installation is often very simple. Four bolts on a set of pillow block bearings normally hold the pulley in place. Loosen the conveyor belt, remove the old pulley and install the magnetized pulley. This type of installation does not require electricity.