MOULD CLAMP-

SATGURU' Mould Clamp is designed especially for low height applications only such as clamping of moulds on plastic injection moulding machines & pressure die casting machines. The Compact front portion of the clamp enables it to penetrate into the limited clamping area of the mould & clamp it. The positioning of forged swivel washer on required curved groove enables the operator to set the center distance between the clamping portion & the clamping bolt as per the nearest tapped hole available on platen (Where there are no T-Slots). No supports are required at the rear of the clamp as the rear portion rests on the platen & front holds the mould. Flanged nut is tightened on the swivel washer which takes care of the positioning of clamp body. These Clamps are equally useful on pressure die casting machines, hydraulic presses & power presses where low height clamping is done.