Listing ID #4302678
Company Information
Ask for more detail from the seller
Contact Supplier
SKEY PRODUTS manufactures LUBOMATIC range of centralised Lubrication System
For Sugar Mill bearings .
The System consists of following components :-
|
PUMP |
A very highly reliable pump with high discharge pressure is incorporated in the system. The pump is reciprocating plunger type pump, which is kept |
|
MOTOR |
A continuous duty electric geared motor with service factor of 2.9 is used. The motor used is a TEFC squirrel cage induction motor suitable for 415 |
|
RESERVOIR |
The pump driven by geared motor is kept immersed in oil to ensure long life & efficient working . The reservoir is of 50 lit . Capacity which is mounted on a pump housing . A level switch fitted to indicate low oil level in tank. Two oil level gauges are located on the front side of reservoir to check the oil level visually. |
|
CHANGE OVER VALVES |
The valve is hydraulically/electrically operated when the pump is switched ON the line 1 is connected and the pressure goes on increasing and when it reaches set high pressure all the points are lubricated as the valve moves forward the line gets blocked and the pressure goes on increasing and line changes to no. 2 line this goes on repeating. The dwell time is adjusted as per requirement and after set dwell time the cycle goes on repeating. |
|
CONTROL PANEL |
Two electric control panels which consists of Main Power Supply, Contactor, MCB etc., It ensure the smooth working of the system. In case of any faults the |
|
PRESSURE SWITCH |
When the line pressure drops down the set pressure. The pressure switch gives signal to control panel & alarm is indicated on the panel & hooter switched ON |
|
RELIEFVALVE |
A relief valve is provide to safeguard the pump from overloading. By adjusting the relief valve setting the delivery pressure can be increased and decreased. |
|
PIPING & FITTINGS |
High quality seamless pipes are used to work under high pressures
Fittings of high quality standards are used to ensure leakage free consistent Working of the system. Various hydraulic fittings are used, such as male stud |
LUBOMATIC Centralised dual line lubrication system basically consists of a reservoir with built in reciprocating plunger pump immersed in the oil, change over valve, dose feeders ( Dual line metering elements ) Pressure Switch, pipes, hose pipes, fittings Electrical Control Panel etc.
In this type of system, there are two main lines of 16 OD, which run parallel to the Sugar Crushing Mill Tandem. From these two main lines, 10 OD Pipes are connected to inlet of dose feeders & the outlet of the dose feeders are connected to the lubrication points ( bearings ).
The valve is hydraulically / electrically operated when the pump is switched ON the line 1 is connected and the pressure goes on increasing and when it reaches set high pressure all the points are lubricated as the valve moves forward the line gets blocked and the pressure goes on increasing and line changes to no. 2 line this goes on repeating. The dwell time is adjusted as per requirement and after set dwell time the cycle goes on repeating.
The discharge of oil can be controlled by
The electric control panel monitors the smooth working of the system. The following step should be followed while operating the system.
|
Reservoir – I Low |
Oil level in reservoir I is below required level. |
|
Reservoir – II Low |
Oil level in reservoir II is below required level. |
|
Low Pressure – I Low |
If the pressure does not get developed in main line the panel will give this fault indication. |
|
Low Pressure – II Low |
If the pressure does not get developed in main line the panel will give this fault indication. |
Nature of Business
Manufacturer / Exporter / Supplier / Retailer
Connect with us
For Buyer 
For Seller 
Help 