Kickless Cable

These cables are manufactured as per customers specification. It acts as a link between the transformer and the spot welding gun for current transfer. Flexible braided wire is used to manufacture the conductor for efficient current transfer. It is available in about 300 MCM to 1000 MCM, which varies as per the requirements of the customers.

 Unique “X-shape” separator maintains strand positioning and equally distributed cooling water flow.

 State-of-the-art 4-wire design to minimize current loss, reduced CO2 emission.

 Electrolytic tough pitch annealed, bare copper wire, 28 AWG, herringbone rope construction for greater flexibility and reduced wear point.

 High temperature internal restraining collars to minimize stress in the bending area.

 Lowest reactance of the class to engage lower primary power demand

 No noticeable pulsation due to low magnetic kicking.

 Improved flexibility, smaller bend radii comparing to previous model.

 Reduced operator fatigue, higher productivity.

 All customized length is available upon request.

1. Test Pressure (water): 6.0 kgs./ cm sq. minimum., 10.0 kgs./cm. sq. maximum

2. Conductor : Electrolytic Copper (99.9% Pure)

3. Rubber hose : As per IS 55821-1986- Cured type.

4. No. of spots : 10 Lacks per cable.

5. Polarity : Alternate

6. Water flow : 6.0 Lit/min at 6 kgf/cm sq.

7. Cable Terminal : As per customer design.

8. Temperature : Withstands up to 50 Degree Centigrade