Modular clean room posts are pre wired with 210 V duplex outlet and switches and mounted in a steel electrical box. Fluorescent gasket light fixtures are 610×1220 mm 4 tube ,120 V,less tubes with energy saving or electronic ballasts. This system is made up of pre-wired connections for light switches, 115v outlets and whips for lights and fan powered Hepas. Electrical run terminates with a “pig-tail” at location designated by the customer and can carry up to 6 circuits to be installed in distribution electrical panels. Final installation of the panel(s) and power to the building is to be installed by a licensed electrician. Outlets are convenience type duplex, three wires, and grounded. Single and 3-way switches are standard.
Fluorescent and LED Lights :

• Full range of fixtures, including sealed energy-efficient, no-maintenance LED panels, makes it easy to configure the optimal lighting for your application
• Select 2′ x 4′ (610 mm x 1219 mm) ceiling module for placement in the ceiling grid, or Teardrop Lights for installation below the grid
• Flow-Through units are ideal with dense FFU ceiling coverage
• LED light strips and panels produce less heat to reduce cooling costs
• Dimmable LED light panels allow brightness adjustments.

Structural Design and Roof Decking
Unless otherwise specified, roof decking, I-beams and support post will be designed for 20-25 lbs. per square foot loads (live load walk-able). Loads of up to 60+lbs and greater are also available. Rooms can be have clear spans of 45+’ and can also be designed as an interregnal part of a mezzanine. Steel roof deck is at least 22 gauge corrugated steel, fire rating is non-combustible, sound deadening with closure gaskets (STC 32). Support posts and I-beams will vary in size based on span and load bearing requirements. Seismic bracing and stamped drawings are available when required.

Modular clean room posts are pre wired with 210 V duplex outlet and switches and mounted in a steel electrical box. Fluorescent gasket light fixtures are 610×1220 mm 4 tube ,120 V,less tubes with energy saving or electronic ballasts. This system is made up of pre-wired connections for light switches, 115v outlets and whips for lights and fan powered Hepas. Electrical run terminates with a “pig-tail” at location designated by the customer and can carry up to 6 circuits to be installed in distribution electrical panels. Final installation of the panel(s) and power to the building is to be installed by a licensed electrician. Outlets are convenience type duplex, three wires, and grounded. Single and 3-way switches are standard.
Fluorescent and LED Lights :

• Full range of fixtures, including sealed energy-efficient, no-maintenance LED panels, makes it easy to configure the optimal lighting for your application
• Select 2′ x 4′ (610 mm x 1219 mm) ceiling module for placement in the ceiling grid, or Teardrop Lights for installation below the grid
• Flow-Through units are ideal with dense FFU ceiling coverage
• LED light strips and panels produce less heat to reduce cooling costs
• Dimmable LED light panels allow brightness adjustments.

Structural Design and Roof Decking
Unless otherwise specified, roof decking, I-beams and support post will be designed for 20-25 lbs. per square foot loads (live load walk-able). Loads of up to 60+lbs and greater are also available. Rooms can be have clear spans of 45+’ and can also be designed as an interregnal part of a mezzanine. Steel roof deck is at least 22 gauge corrugated steel, fire rating is non-combustible, sound deadening with closure gaskets (STC 32). Support posts and I-beams will vary in size based on span and load bearing requirements. Seismic bracing and stamped drawings are available when required.