Infant Radiant Baby Warmer

Listing ID #4224301

Features:

• Micro Controller based Electronics
• Controls - Servo Skin/ Apgar
• Pre-warm - Use the equipment with 30% Heater Output in Manual Mode.
• Programmable Mute time
• No need of calibration required for temperature probe.
• High Intensity Quartz Heating element for effective Radiation (Ceramic heater Optional)
• Halogen Observation Lamp
• The Heater Module rotates 90° to both sides to facilitate
• X-Ray Procedures.
• The Parabolic Reflector is designed to send uniform heat to the bed surface.
• Memory Backup to restore set temperature and previous mode, in case of power failure.
• Optimum Bed dimensions ensure optimum work space for the nursing staff.
• Comprehensive Alarms and safety cut-offs.
• Alert (Alarm) when sensor is detached from the patient's skin (optional)
• Instant Warming and Uniform heating

Controller

• Electronics : High speed micro controller
• Mode of operation : Servo skin, manual & apgar
• Skin mode control range : 30 Deg. C to 38 Deg. C
• Manual mode timer : 1 min to 15 mins (selectable), 15 mins to 30 mins (optional)
• Apgar timer : Alerts at 1, 5, 10, 15 & 20 mins (selectable)
• Percentage of heater output : 10% to 100% in 10% increments
• Memory back up : Equipment restores the previous settings
• Programmable mute time : User can select the mute time
• Safety heater cut off : If the skin sensor is removed from the baby's skin
• Over temperature heater cut off : If the skin temperature is >39 Deg. C in any skin/manual mode
• Temperature sensor (probe) : Thermistor sensor
• Accuracy of skin sensor : ±0.1 C
• Accuracy of skin probe Interchangeability : 0.2 C
• Calibration of skin sensor (probe) : No need of calibration after Changing new probe
• Heater element : Quartz Infrared heater Ceramic heater (optional)

Other Details

• Power rating : 230V AC, 50Hz, 700 W
• Maximum heater wattage : 600 Watts
• Maximum power requirement : 700 Watts
• Examination light : 12V, 50W Halogen lamp
• X-ray facility : Underneath the bed
• Mattress tilt : ±30 degrees on both sides
• IV pole : Maximum load 2.2 Kg
• Pump mounting pole : Maximum load 2.2 Kg
• Castor : 4” castors 4 Nos. (2 with brake & 2 without brake
• Monitor shelf : 2 Nos. Fixed
• Height adjustable heater module : Available only in nice 2010
• Cabinet : Available only in nice 2010BC
• Operating noise level : <50 dBA

Controller Alarms:

• Check patient If the skin sensor is removed from
• the baby's skin
• Skin temperature high > 1.0 C from the set temperature
• Skin temperature low < 1.0 C from the set temperature
• Skin temperature probe fail Probe short or open
• Over temperature If skin temperature is 39 C
• Heater fail Heater defect
• System fail Electronic component defect
• Power fail AC power interruption

Environmental

• Operating temperature - 15° C to 35° C
• Storage temperature - -20° C to 60° C
• Operating humidity - 5% to 90% RH, non condensing
• Storage humidity - 0% to 99% RH, non condensing
• Altitude - Sea level to 1-9 miles, 3 Km
• Quality - ISO 9001:2000 & ISO 13485:2003
• Electrical & product safety - IEC 60601-1, IEC 60601-1-2, IEC 60601-1-4, IEC 60601-2-21