Digital Servo Voltage Stabilizer

In regulator we are using heavy section of electrolytic grade rectangular copper strip instead of copper wire to minimum the losses. It increases efficiency of equipment. We are also using self-lubrication carbon roller assemblies which offer more reliability and trouble free performance of the equipment.

High Reliability
Better Efficiency
Easy maintenance
Rolling Contact Type Technology

Range: 10 KVA To 3000KVA

NOTE: Non-standard input and output rage are also available against specification requirements.

Automatic Voltage Stabilizer is available in a wide range and various models. The standard three phase models are suitable for balance input supply and fairly balanced loads.

Gemax servo voltage stabilizers consist of a solid state digital circuit, which controls the servimeter. The servomotor is mechanically couple to the arms of auto transformer. The second of the buck boost transformer is in series with mains supply. The solid state conrol circuit compares the feedback signal with the fixed reference & gives a control signal to rotate servometer. This adjust the output voltage to set level with in tolerence limits.

Copper Wound Vacuum impregnated trasformer.
solid state glass epoxy plug in control card
very low internal impedance
No effect on load power factor
High Efficiency better then 95%
High reliability servometer
Wide requency range from 45hz to 55 hz
No effect by any transient over voltage surges
Auto-manual operation
Voltage limit Indicators
Output volatge adjustable
input/output voltage adjustable
fast correction speed (20 Volts per sec.)
Oil/Air cooled
110 Volts outpt can also be given.
High voltage cut off/low voltage cut off time delay facility single phasing prevention and digital display
Enviroment: The quoted correct rating apply to ambient temperature from 15C to45C at higher temperature derate the output current.