High Density Cartridge Heaters

Listing ID #4610198

High-wattage cartridges belong to a new generation of electric heat-ing elements; they make it possible to use high watt loads in small spaces, thus ensuring excellent reliability in heavy-duty work condi-tions. Their special construction technology makes them the most advanced type of heating elements. The entire length of the wire wound around a magnesium oxide core is in a far away position from the axis of the cartridge, very close to the metal sheath, with a very thin and compressed insulating wall in between; this allows excellent heat exchange that allows a much lower temperature of the resis-tance wire than in other heaters in which the wire is in a deeper posi-tion. Besides the use of advanced technology and precise inspection techniques in their manufacturing.

1. The hole where it is going to be isntalled, the cartridge must have a diameter tolerance between –0.02 to –0.06 mm (depends upon watt density, higher watt density must have lower tolerance).
2. The cartridge must not be longer than the hole where it is installed.
3. Connecting leads must not be scratched, flattened, stained, wet, etc.
4. The cartridge heaters cannot work in open air.
5. Controlling systems must be used with the cartridge heaters.
6. Resistance Tolerance: + 10% - 5%
7. Wattage Tolerance: + 5% - 10%
8. Length Tolerance: +/- up to 5mm
9. The sensors for the controller should be placed between the working surface of the part & the heaters. The temperature of the part approximately half inch away from the heaters is used in selecting maximum allowable watt density.
10. Control of power is an important consideration in high watt density appl cations. On/Off control is frequently utilised, but it can cause wide excursions in the temperature of the heaters & working parts. Thyristor power control are valuable in extending the life of the high watt density heaters, since they effectively eliminate On/Off cycling.