Heavy Duty Plano Miller

Cat. No. : WM-018
HEAVY DUTY PLANO MILLER
FOR BETTER ACCURACY, FINISH AND PRODUCTIVITY, AVALIABLE IN THREE MODLES 
(a) PLANO MILLER GEAR TYPE
(b) PLANO MILLER BELT TYPE
(c) PLANO MILLER ELECTRO MAGNETIC DRIVE TYPE
SPECIFICATIONS 
L in the Model indicates any length of stroke required between 6' to 40' 
Width between columns L 3ft. L 4ft. L 4.5ft. L 5ft. L 5.5ft. L 6ft. L 7ft. 
Length of Stroke in feet 6 ft. to 40 ft. as per order / requirement 
Length of Stroke in Meters 1.8m to 12m as per order / requirement 
. CAPACITY 
Width between colums 900 1220 1372 1524 1676 1828 2133 
Height under Cross Rail 900 2300 1372 1524 1676 1828 2133 
. TABLE 
Working Surface Length EQUAL TO LENGTH OF STROKE L 
No. of T-Slots 5 5 5 6 6 6 7 
Width of T-Slots 19 19 19 19 19 19 19 
Distance between T-Slots 127 127 148 148 148 190 190 
. MILLING HEADS 
No. of Milling Heads ONE, TWO OR THREE AS PER ORDER 
Horizontal Traverse of Milling Head on Cross Rail 760 900 950 1200 1350 1500 1760 
Max. swivel of Milling Head to either side 50 60 60 60 60 60 60 
. CROSS RAIL 
Vertical Traverse of Cross rail mm (elevating) 750 1200 1330 1500 1650 1800 2060 
Elevating Traverse of side Milling Head 600 850 100 1150 1300 1400 1750 
. MILLING HEADS GENERAL DUTY OR HEAVY DUTY as per order No. of speeds 6 6 
Range of speeds in RPM 55,80,100,130,170,260 50 to 270 rpm 
Motor 3 phase 440 volts 3 HP/1440 RPM 5 HP/1440 RPM 
Spindle dia at Nose 85mm 125mm 
Vertical traverse of quill 70mm 100MM 
Vertical Traverse operation Hand operated Hand operated 
Micro Feed Hand operated 1 small division = 0.1 mm One 
small Division = 0.1mm 
Feed of Trolly for Milling 32mm to 100mm per minute 32mm to 100mm per minute 
Cutter Dia 80mm to 10mm 120mm to 150mm 
Spindle Nose Taper ISO-40 ISO-50 
Holding of cutter By Draw Bolt Either by draw bolt / bar or bolts on spindle nose 
Extra heavy duty milling head with 7.5 / 10 HP also available on request