HALF PIPE SLEEVE

Listing ID #4304560

Half Pipe Sleeve » General

Half Repair pipe Sleeves are designed to avoid a costly shut down. Existing lines can be cased without thru-put loss, because it is not necessary to shut down the carrier line to perform the required repair. A full scope of sizes, ASTM grades of steel plate (structural and pressure vessel quality), wall thickness and longitudinal edge options are available. Half Sole Repair Sleeves, also called split casing or half wrap, are custom-fabricated to your specifications, to assure a precision product and secure fit. There are four types of material available, two pressure-rated steels and two structural-grade steel. The pressure-rated steel sleeves can be used to repair leaking and non-leaking defects while the structural-grade steel sleeves can function as reinforcement for a defective area.

The steel repair sleeves can be used for internal and external corrosion, gouges, dents, grooves, arc burns, cracks, defective girth welds, laminations and leaks.
Pressure containing sleeves feature a wall thickness equal to or greater than required for the maximum allowable operating pressure or the full strength of the pipe being repaired. The steel Repair sleeve material is certified and the carbon equivalent will not exceed 0.45 percent. Each half-sole segment comes with one pre-crimped back-up strip.
Steel Repair Sleeves can be used as pads or cradles for above ground piping, drain tile supports and patches (segments in 90° and 180° arcs, from 6-inches to 10 feet in length are available as specials).
Each Steel Repair Sleeve has standard bevels with a back-up strip and material certifications. Sleeve ends are square cut. Back-up strip are not included with Standard Girth Weld Steel Repair Sleeves but are available as special order.

Material used are structural quality carbon steel or pressure vessel quality carbon steel plates, which are to ASTM specifications, and in the following grades:
API 5L Gr B, X42, X46, X52, X56, X 60, X 65, X70 - PSL 1 - PSL2 (minimum yield 245000 / 52000 / 60000 / 65000 / 70000)
ASTM A36 (structural; minimum yield 36,000 psi)
ASTM A572 GR42, GR50, GR55, GR60, GR65 (structural; minimum yield 29,000 psi)
ASTM A516 GR55, GR60, GR65, GR70 (pressure vessel; minimum yield 38,000 psi)
ASTM A537 Class I, Class 2, Class 3 (pressure vessel; minimum yield 50,000 psi) 
EN 10025 - S235, S275, S355, S450
The chemical composition does not exceed the percentages specified for the ASTM material ordered. Repair sleeves are fabricated from plate with low carbon equivalency for good weld ability.
The maximum allowable carbon equivalency (CE) quality carbon steel plates will be based on the heat analysis.
The maximum allowable carbon equivalency (CE) pressure vessel quality carbon steel plates will be based on the heat analysis, in most cases.

Note : The sleeve can be manufactured in any grade as per the application & client requirements.

Half Repair Pipe Sleeve is formed by rolling, step braking, or die forming without the use of heat treating.
Longitudinal edges of the Half Sole are beveled for welding, if requested, at 30º. The bevel are a mechanical type and/or produced by plasma torch burning.
Half Repair Pipe Sleeve ends have sheared square edges for fillet welding, unless square end bevel is requested, and are available in maximum lengths as per clients requirements.

We can manufacture half pipe sleeve in any size as per client's requirement.