Blue Mechanical FRP Forced Draft Cooling Towers, Capacity : 0-500L, 1000-1500L, 500-1000L

Listing ID #6847793

forced draft cooling tower -15 tr-1500 tr  capacity

• capacity: the cooling tower should be designed to meet the specific heat rejection requirements of the system it serves. the capacity of the cooling tower should be specified in terms of the flow rate of water to be cooled, measured in gallons per minute (gpm).
• materials of construction: the cooling tower should be constructed of materials that are resistant to corrosion, decay, and other environmental factors. common materials of construction include fiberglass, concrete, and stainless steel.
• fan: the fan should be a direct-drive, axial-flow type with adjustable pitch blades to provide the required air flow. the fan should be designed to operate at the specified performance range and meet the noise requirements.
• water distribution system: the water distribution system should be designed to uniformly distribute water over the entire fill surface area. the system should be designed to provide a minimum of 0.25 gallons per minute of water flow per square foot of fill area.
• fill: the fill should be of a type that provides maximum heat transfer, and resistance to fouling and scaling. it should be constructed of corrosion-resistant materials.
• drift eliminator: the drift eliminator should be of a design that effectively reduces the amount of water vapor that escapes from the cooling tower. it should be constructed of corrosion-resistant materials.
• basin: the basin should be designed to provide sufficient volume to contain the maximum flow of water in the tower, plus a safety margin. it should be constructed of corrosion-resistant materials.
• support structure: the support structure should be designed to withstand the loads imposed by the cooling tower, including wind, seismic, and dead loads. it should be constructed of materials that are suitable for the environmental conditions.
• electrical requirements: the electrical requirements should be specified, including the voltage, phase, and frequency of the power supply. the fan motor should be selected to meet the specified requirements.
• controls: the controls should be designed to provide the necessary functionality for safe and efficient operation of the cooling tower. they should include temperature, flow, and pressure sensors, as well as alarms and shut-off devices.