Eye Rolling Machine

Listing ID #3902948

Features:
- All fabricated design
- Supplied with quick lifting centre pin arrangement with hand operated lever
- Capacity maximum of leaf eye rolling 100 x 12 mm

Installation:
- The machine should be installed on a concrete foundation close to the heating furnace. Hot end chambers / pre-bending of leaf spring should be done.
- After Hot end chamfering of lead on press, hot flat end should be reheated. Two Eye Rolling diameter pins should kept ready. One pin is used for eye rolling while the other pin cools in the water tank kept below the eye rolling machine. Corresponding to the pin size, the required bush is to be mounted on the Eye Rolling Machine. Please make all size pins and corresponding bushes as per your requirement. 

Brief Operation:
Put eye rolling pin in its position. Place the pre-bent portion of the hot leaf into the machine, tighten the clamping screw and manually push the pivot end of the machine using a long pipe. After completing 3/4th bend / eye, release the clamping screw and pull the pivot end of the machine to the starting point. Again clamp the screw and push the pivot end again to complete the eye. Release the screw and pull the pin upwards. Remove the eye using a hammer and die correct the eye size and Inside Diameter. Put this eye rolling pin in the water tank for cooling and use the other pin for the next rolling operation.