Drive a 2-phase bipolar stepper motor or two DC motors with the L298 dual H-Bridge chip, mounted on this handy breakout board along with all necessary peripherals! The L298 motor driver module features: • Finned Aluminum Heatsink for the L298 IC • Clamping Rectifiers • Filter Capacitors for logic-power and moto-power busses • Onboard 5-Volt DC Regulator (A jumper selects between external 5-Volt power or the onboard 5-volt regulator.) • Screw Terminal connections for ground, motor power, 5-volt power, and motor outputs • 0.1 inch-pitch header pins for logic inputs • Jumpers to tie the enable inputs to ground (if desired) • Switches up to 2 amps per channel The overall PC Board dimensions are 1.70" Square x 1.16" Tall. Mounting holes in each corner accept 18" screws or standoffs. This module is easy to get running, with only 4 logic pins required.

Drive a 2-phase bipolar stepper motor or two DC motors with the L298 dual H-Bridge chip, mounted on this handy breakout board along with all necessary peripherals! The L298 motor driver module features: • Finned Aluminum Heatsink for the L298 IC • Clamping Rectifiers • Filter Capacitors for logic-power and moto-power busses • Onboard 5-Volt DC Regulator (A jumper selects between external 5-Volt power or the onboard 5-volt regulator.) • Screw Terminal connections for ground, motor power, 5-volt power, and motor outputs • 0.1 inch-pitch header pins for logic inputs • Jumpers to tie the enable inputs to ground (if desired) • Switches up to 2 amps per channel The overall PC Board dimensions are 1.70" Square x 1.16" Tall. Mounting holes in each corner accept 18" screws or standoffs. This module is easy to get running, with only 4 logic pins required.