Double Acting Pumps

IDEAL FOR USE WITH SMALL HYDRAULICALLY POWERED TOOLS.

• Vanguard Jr.® pumps provide two-speed high performance in a light-weight, compact package.
• Gauge port provided on pump. Metal reservoir on all models.
• Equipped with a 1⁄2 hp (0,37 kW), 115 volt, 60/50 Hz single phase motor that starts under load, even at reduced voltage.
• Low amperage draw permits use with smaller generators and low amperage circuits.
• All pumps have a 10 foot (3 m) remote control (PE183C has 25 foot (7,6 m) remote control).
• CSA rated for intermittent duty. Noise level of 85-90 dBA.

For operating hydraulic crimping, cutting or other tools:

• No. PE183C – For crimping or pressing applications. Has special electrical circuitry to pulse/advance, hold at full pressure, build to a predetermined pressure, release and reset circuit. Features separate emergency return switch.
• No. PE184C – Allows you to alternately operate a spring-return cutting and/or crimping tool without disconnecting either tool. Select port connection with manual 4-way valve, start pump with remote control hand switch and extend connected tool. When hand switch is switched to off, pump stops and automatic valve opens, allowing tool to return. In center (neutral) position, manual control valve holds tool in position at time valve is shifted.

* Also for use with special single-acting cylinder applications.
** Available with 220 Volt, 60/50 Hz motor (to order, place suffix “50-220” behind pump order number). Specify voltage when ordering.
† Holds when motor is shut off and valve is in “advance” position.
†† Pumps supplied with 7,6 l oil (usable oil is 5,7 l), will hold 9,5 l when filled to within 13 mm below reservoir cover plate.
∞ Not to be used for lifting.