Digital Epstein Tester ( Ep 400) 20*30*100

EP-400 is designed to measure AC magnetic properties of flat rolled magnetic materials at high frequency by using Wattmeter, Ammeter, Voltmeter and Source. Epstein bridge test method is a fundamental method for evaluating the magnetic performance of flat-rolled magnetic materials in either sheared or stress relief annealed condition. This test method is suitable for design, specification acceptance, service evaluation, and research and development.

EP-400 has digital controlled crystal accurate 16 Bit sine wave Generator, which provides 25 Hz to 450 Hz harmonics free non distorted power for testing of specimen. It has in built measuring meter, like Flux Voltmeter, RMS Voltmeter, RMS Ammeter, Peak Ammeter, Wattmeter and Power Factor meter with digital sampling method. These measuring devices are (temper proof) precisely calibrated to achieve high accuracy and long term stability. Accuracy and stability of EP-350 is better than specified in national and international standards. (Reference to ASTM: 343, IEC: 60404-2, BIS: 649)

Fully Automatic Test Method

You can get the complete test report at nine different induction points within few minutes. You only need to insert strips in the bridge and enter the weight, length and density of material in software. EP-400 starts taking result at your defined nine different induction point automatically. For testing at each induction, it sets frequency, flux volt & induction automatically using digital sampling method by micro controller. After competition of testing, software generates report in Excel sheet.