Control systems or display elements Like e.g. digital display require standard signals of e. g. 0…20mA as an input signal. As in the current application path to be measured, large currents of upto 4000 A can occur, you need current X’mers that convert these high current to 1 A AC or 5 A AC. Then downstream current transducers uses this current to create typical standards signals that can be processed by e.g. control system.

Current Monitoring:

With the help of monitoring relays (IF monitoring), currents can be monitored and over currents can be can be signaled via a switching output. As typical monitoring relays only have a measuring input of up to 10 A maximum, a current X’mers the high currents into smaller ones.

Motor Management :

The electronic motor managers (EMMs), among other things, serve for motoring a drive system or a 3 – phase load. For this, 3 currents have to be measured and monitored. Currents of more than 5 A cannot be processed by the EMM current measuring input. Therefore, separate current X’mers has to be installed before the current measuring input so that the primary current is transformed into 5 A maximum.

Test Circuits :

Test disconnect terminal blocks and slide terminal blocks were developed especially for the use in current X’mer secondary circuits. The terminals can be fitted on both sides with fixed and switchable jumpers as well as test sockets.

Control systems or display elements Like e.g. digital display require standard signals of e. g. 0…20mA as an input signal. As in the current application path to be measured, large currents of upto 4000 A can occur, you need current X’mers that convert these high current to 1 A AC or 5 A AC. Then downstream current transducers uses this current to create typical standards signals that can be processed by e.g. control system.

Current Monitoring:

With the help of monitoring relays (IF monitoring), currents can be monitored and over currents can be can be signaled via a switching output. As typical monitoring relays only have a measuring input of up to 10 A maximum, a current X’mers the high currents into smaller ones.

Motor Management :

The electronic motor managers (EMMs), among other things, serve for motoring a drive system or a 3 – phase load. For this, 3 currents have to be measured and monitored. Currents of more than 5 A cannot be processed by the EMM current measuring input. Therefore, separate current X’mers has to be installed before the current measuring input so that the primary current is transformed into 5 A maximum.

Test Circuits :

Test disconnect terminal blocks and slide terminal blocks were developed especially for the use in current X’mer secondary circuits. The terminals can be fitted on both sides with fixed and switchable jumpers as well as test sockets.