Another accompaniment specifically used on concrete surfaces. Recommended to be applied at least 4-5 hours before the application of road marking paint for better bonding and smooth application on Concrete surfaces.
DIRECTIONS FOR USE

• Heat the material to 180 - 200°C in the pre - heater with adequate agitation till the material becomes a homogenized liquid.
• Ensure that the road surface is clean, free from dust and moisture.
• Heavy deposits of paint require removal.
• For aged asphalt roads and concrete roads, a primer coat is recommended before 20-30 minutes for proper bonding of the material with the road surface.
• Ensure that the primer is thoroughly dry and void of solvent prior to application of the thermoplastic material.
• Ensure temperature of 180 – 200°C and adequate agitation during application.
• Do not hold thermoplastic above 180°C for more than 6 hours.
• Do not heat the material above 220°C at any point of time .
• Change in colour indicates that the material has been scorched owing to overheating and needs to be discarded .
• Drop - on glass beads must be immediately deposited after thermoplastic application.

Another accompaniment specifically used on concrete surfaces. Recommended to be applied at least 4-5 hours before the application of road marking paint for better bonding and smooth application on Concrete surfaces.
DIRECTIONS FOR USE

• Heat the material to 180 - 200°C in the pre - heater with adequate agitation till the material becomes a homogenized liquid.
• Ensure that the road surface is clean, free from dust and moisture.
• Heavy deposits of paint require removal.
• For aged asphalt roads and concrete roads, a primer coat is recommended before 20-30 minutes for proper bonding of the material with the road surface.
• Ensure that the primer is thoroughly dry and void of solvent prior to application of the thermoplastic material.
• Ensure temperature of 180 – 200°C and adequate agitation during application.
• Do not hold thermoplastic above 180°C for more than 6 hours.
• Do not heat the material above 220°C at any point of time .
• Change in colour indicates that the material has been scorched owing to overheating and needs to be discarded .
• Drop - on glass beads must be immediately deposited after thermoplastic application.