Cement Plant

Cement is typically made from limestone and clay or shale. These raw materials are extracted from the quarry crushed to a very fine powder and then blended in the correct proportions.

Details :

• This blended raw material is called the 'raw feed' or 'kiln feed' and is heated in a rotary kiln where it reaches a temperature of about 1400 C to 1500 C. In its simplest form, the rotary kiln is a tube up to 200 metres long and perhaps 6 metres in diameter, with a long flame at one end. The raw feed enters the kiln at the cool end and gradually passes down to the hot end, then falls out of the kiln and cools down.
• The material formed in the kiln is described as 'clinker' and is typically composed of rounded nodules between 1mm and 25mm across.
• After cooling, the clinker may be stored temporarily in a clinker store, or it may pass directly to the cement mill.
• The cement mill grinds the clinker to a fine powder. A small amount of gypsum - a form of calcium sulfate - is normally ground up with the clinker. The gypsum controls the setting properties of the cement when water is added.

Cement Plant Equipment :

• Feeders
• Elevators
• Dryers
• Grinding units
• Air slides/lifts
• Hoppers
• Vibrating screens
• Pre calcines
• Coolers
• Mill components
• Mill bearings
• Vertical shaft kilns
• Rotary shaft kilns
• Separators
• Crushers